IDEAS home Printed from https://ideas.repec.org/a/eee/renene/v253y2025ics0960148125013175.html

Optimized sustainable thin-film thermoelectric generator design for sensor powering using machine learning

Author

Listed:
  • Sheikholeslami, M.
  • Ataollahi, N.
  • Khatirzad, H.
  • Scardi, P.
  • Boora, Faranack M.

Abstract

This study explores the optimization and development of a thin-film thermoelectric generator (TEG) designed for sensor powering, with a primary emphasis on maximizing electrical power. Sustainable materials were chosen for the TEG legs, with Cu0.85Ag0.15FeS2 (CAFS) as the n-type material and Cu2SnS3 (CTS) as the p-type material, while soda lime glass (SLG) was implemented as the substrate. Utilizing these eco-friendly materials addresses a pressing need for sustainable solutions in TEG technology and aligns with modern environmental and cost-reduction goals. Machine learning techniques, specifically polynomial regression and Differential Evolution implemented in Python, were applied to identify the optimal geometric parameters of the TEG, aiming for peak electrical power. Experimental correlations for the temperature-dependent electrical and thermal properties were derived and integrated into a simulation model created in COMSOL Multiphysics. These simulations were validated with prior experimental data, showing excellent accuracy, which supports the model's reliability in predicting TEG performance. The simulation examined a range of parameter values, revealing that a greater width of the n-type CAFS legs, coupled with a thinner SLG substrate, significantly enhances power output. Additionally, configuring the TEG with an extended length of the hot surface and a shorter insulated section further increased performance. With the optimized parameters, the TEG achieved a power output of 2.372 nW—an improvement of approximately 17.68 % compared to the maximum power from the initial optimization data. The optimized thin-film TEG design generates power solar-assisted sensor, utilizing a concentrated solar system for the hot side and an air-based heat sink for the cold side to create the required temperature differential.

Suggested Citation

  • Sheikholeslami, M. & Ataollahi, N. & Khatirzad, H. & Scardi, P. & Boora, Faranack M., 2025. "Optimized sustainable thin-film thermoelectric generator design for sensor powering using machine learning," Renewable Energy, Elsevier, vol. 253(C).
    • Handle: RePEc:eee:renene:v:253:y:2025:i:c:s0960148125013175
    DOI: 10.1016/j.renene.2025.123655
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0960148125013175
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.renene.2025.123655?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to

    for a different version of it.

    References listed on IDEAS

    as
    1. Tappura, Kirsi & Juntunen, Taneli & Jaakkola, Kaarle & Ruoho, Mikko & Tittonen, Ilkka & Ritasalo, Riina & Pudas, Marko, 2020. "Large-area implementation and critical evaluation of the material and fabrication aspects of a thin-film thermoelectric generator based on aluminum-doped zinc oxide," Renewable Energy, Elsevier, vol. 147(P1), pages 1292-1298.
    2. Cotfas, D.T. & Enesca, A. & Cotfas, P.A., 2024. "Enhancing the performance of the solar thermoelectric generator in unconcentrated and concentrated light," Renewable Energy, Elsevier, vol. 221(C).
    3. Kane, Aarti & Verma, Vishal & Singh, Bhim, 2017. "Optimization of thermoelectric cooling technology for an active cooling of photovoltaic panel," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 1295-1305.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Khatirzad, H. & Sheikholeslami, M., 2025. "Numerical investigation of hybrid nanofluid flow in a finned heat sink integrated with a concentrated solar system and thermoelectric generator," Renewable Energy, Elsevier, vol. 245(C).
    2. Chen, Lingen & Lorenzini, Giulio, 2023. "Heating load, COP and exergetic efficiency optimizations for TEG-TEH combined thermoelectric device with Thomson effect and external heat transfer," Energy, Elsevier, vol. 270(C).
    3. Liao, Tianjun & He, Qijiao & Xu, Qidong & Dai, Yawen & Cheng, Chun & Ni, Meng, 2021. "Coupling properties and parametric optimization of a photovoltaic panel driven thermoelectric refrigerators system," Energy, Elsevier, vol. 220(C).
    4. Saxena, Ashish & Deshmukh, Sandip & Nirali, Somanath & Wani, Saurabh, 2018. "Laboratory based Experimental Investigation of Photovoltaic (PV) Thermo-control with Water and its Proposed Real-time Implementation," Renewable Energy, Elsevier, vol. 115(C), pages 128-138.
    5. Bevilacqua, Piero & Bruno, Roberto & Arcuri, Natale, 2020. "Comparing the performances of different cooling strategies to increase photovoltaic electric performance in different meteorological conditions," Energy, Elsevier, vol. 195(C).
    6. Yang, Yong & Tian, Congxiang & Wang, Suqi & Abdalla, Ahmed N., 2024. "Enhancing building energy efficiency: Numerical analysis of a hybrid thermoelectric ventilation system and earth-air heat exchange with photovoltaic-thermoelectric power integration for heating and cooling loads," Energy, Elsevier, vol. 311(C).
    7. Ding, Yu & Klemeš, Jiří Jaromír & Zhao, Pengbo & Zeng, Min & Wang, Qiuwang, 2022. "Numerical study on 2-stage phase change heat sink for cooling of photovoltaic panel," Energy, Elsevier, vol. 249(C).
    8. Yang, Li-Hao & Liang, Jyun-De & Hsu, Chien-Yeh & Yang, Tai-Her & Chen, Sih-Li, 2019. "Enhanced efficiency of photovoltaic panels by integrating a spray cooling system with shallow geothermal energy heat exchanger," Renewable Energy, Elsevier, vol. 134(C), pages 970-981.
    9. Kwan, Trevor Hocksun & Yao, Qinghe, 2019. "Preliminary study of integrating the vapor compression cycle with concentrated photovoltaic panels for supporting hydrogen production," Renewable Energy, Elsevier, vol. 134(C), pages 828-836.
    10. Yang, Zhenning & Wang, Fuqiang & Fu, Zhichang & Dong, Yan & Zou, Huichuan & Chen, Xudong & Yan, Yuying & Zhang, Shuai, 2024. "Thermoelectric system investigation with the combination of solar concentration, greenhouse and radiative cooling for all-day power generation," Renewable Energy, Elsevier, vol. 231(C).
    11. Kim, Jinsu & Jamdade, Shubham & Yuan, Yanhui & Realff, Matthew J., 2024. "System-level analysis of atmospheric water extraction with MIL-100 (Fe) for design and optimal site selection using meteorological characteristics," Energy, Elsevier, vol. 299(C).
    12. Cai, Yang & Wang, Lei & Ding, Wen-Tao & Liu, Di & Zhao, Fu-Yun, 2019. "Thermal performance of an active thermoelectric ventilation system applied for built space cooling: Network model and finite time thermodynamic optimization," Energy, Elsevier, vol. 170(C), pages 915-930.
    13. Li, Dianhong & Xuan, Yimin & Yin, Ershuai & Li, Qiang, 2018. "Conversion efficiency gain for concentrated triple-junction solar cell system through thermal management," Renewable Energy, Elsevier, vol. 126(C), pages 960-968.
    14. Huang, Yuewu & Zhao, Yonggang, 2023. "Performance assessment of a perovskite solar cell-driven thermionic refrigerator hybrid system," Energy, Elsevier, vol. 266(C).
    15. Mariam, Ezrah & Ramasubramanian, Brindha & Sumedha Reddy, Vundrala & Dalapati, Goutam Kumar & Ghosh, Siddhartha & PA, Thanseeha Sherin & Chakrabortty, Sabyasachi & Motapothula, Mallikarjuna Rao & Kuma, 2024. "Emerging trends in cooling technologies for photovoltaic systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 192(C).
    16. Cengiz, Mazlum & Kayri, İsmail & Aydın, Hüseyin, 2024. "A collated overview on the evaporative cooling applications for photovoltaic modules," Renewable and Sustainable Energy Reviews, Elsevier, vol. 197(C).
    17. Siecker, J. & Kusakana, K. & Numbi, B.P., 2017. "A review of solar photovoltaic systems cooling technologies," Renewable and Sustainable Energy Reviews, Elsevier, vol. 79(C), pages 192-203.
    18. Feng, Mengqi & Lv, Song & Deng, Jingcai & Guo, Ying & Wu, Yangyang & Shi, Guoqing & Zhang, Mingming, 2023. "An overview of environmental energy harvesting by thermoelectric generators," Renewable and Sustainable Energy Reviews, Elsevier, vol. 187(C).

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:renene:v:253:y:2025:i:c:s0960148125013175. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/renewable-energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.