IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v35y2010i1p101-110.html
   My bibliography  Save this article

Heat transfer and pressure drop in corrugated channels

Author

Listed:
  • Elshafei, E.A.M.
  • Awad, M.M.
  • El-Negiry, E.
  • Ali, A.G.

Abstract

The convective heat transfer and pressure drop characteristics of flow in corrugated channels have been experimentally investigated. Experiments were performed on channels of uniform wall temperature and of fixed corrugation ratio over a range of Reynolds number, 3220≤Re≤9420. The effects of channel spacing and phase shift variations on heat transfer and pressure drop are discussed. Results of corrugated channels flow showed a significant heat transfer enhancement accompanied by increased pressure drop penalty. The average heat transfer coefficient and pressure drop enhanced by a factor of 2.6 up to 3.2 and 1.9 to 2.6 relative to those for parallel plate channel, respectively, depending upon the spacing and phase shift. The friction factor increased with increasing channel spacing and its phase shift. The effect of spacing variations on heat transfer and friction factor was more pronounced than that of phase shift variation, especially at high Reynolds number. Comparing results of the tested channels by considering the flow area goodness factor (j/f), it was better for corrugated channel with spacing ratio, ɛ≤3.0 and of phase shift, Ø≤90°. Comparisons of the present data with those available in literature are presented and discussed.

Suggested Citation

  • Elshafei, E.A.M. & Awad, M.M. & El-Negiry, E. & Ali, A.G., 2010. "Heat transfer and pressure drop in corrugated channels," Energy, Elsevier, vol. 35(1), pages 101-110.
    • Handle: RePEc:eee:energy:v:35:y:2010:i:1:p:101-110
    DOI: 10.1016/j.energy.2009.08.031
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S036054420900382X
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2009.08.031?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Mohammed, Kafel A. & Abu Talib, A.R. & Nuraini, A.A. & Ahmed, K.A., 2017. "Review of forced convection nanofluids through corrugated facing step," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 234-241.
    2. Hwang, Sang Dong & Kwon, Hyun Goo & Cho, Hyung Hee, 2010. "Local heat transfer and thermal performance on periodically dimple-protrusion patterned walls for compact heat exchangers," Energy, Elsevier, vol. 35(12), pages 5357-5364.
    3. Li, Qi & Flamant, Gilles & Yuan, Xigang & Neveu, Pierre & Luo, Lingai, 2011. "Compact heat exchangers: A review and future applications for a new generation of high temperature solar receivers," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(9), pages 4855-4875.
    4. Stanislav Kotšmíd & Zuzana Brodnianská, 2022. "The Effect of Diameter and Position of Transverse Cylindrical Vortex Generators on Heat Transfer Improvement in a Wavy Channel," Mathematics, MDPI, vol. 10(23), pages 1-22, December.
    5. Osorio, Julian D. & Hovsapian, Rob & Ordonez, Juan C., 2016. "Effect of multi-tank thermal energy storage, recuperator effectiveness, and solar receiver conductance on the performance of a concentrated solar supercritical CO2-based power plant operating under di," Energy, Elsevier, vol. 115(P1), pages 353-368.
    6. Liu, X.P. & Niu, J.L., 2014. "An optimal design analysis method for heat recovery devices in building applications," Applied Energy, Elsevier, vol. 129(C), pages 364-372.
    7. Mardiana, A. & Riffat, S.B., 2013. "Review on physical and performance parameters of heat recovery systems for building applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 28(C), pages 174-190.
    8. El-Sebaii, A.A. & Al-Snani, H., 2010. "Effect of selective coating on thermal performance of flat plate solar air heaters," Energy, Elsevier, vol. 35(4), pages 1820-1828.
    9. Jingang Yang & Yaohua Zhao & Aoxue Chen & Zhenhua Quan, 2019. "Thermal Performance of a Low-Temperature Heat Exchanger Using a Micro Heat Pipe Array," Energies, MDPI, vol. 12(4), pages 1-16, February.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:35:y:2010:i:1:p:101-110. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.