IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v35y2010i10p4102-4106.html
   My bibliography  Save this article

Bituminous coal combustion in a full-scale start-up ignition burner: Influence of the excess air ratio

Author

Listed:
  • Liu, Chunlong
  • Li, Zhengqi
  • Kong, Weiguang
  • Zhao, Yang
  • Chen, Zhichao

Abstract

A start-up ignition burner has been proposed to reduce oil fuel consumption during the firing-up process and partial-load operation. To investigate the influence of different excess air ratios on bituminous coal combustion in the start-up ignition burner, full-scale reacting-flow experiments were performed for an experiment setup. The ignition burner was identical to that normally used in an 800 MWe utility boiler. Gas temperature distributions in the burner were obtained for excess air ratios of 0.56, 0.75, 0.98 and 1.14 (corresponding to primary air velocities of 17, 23, 30 and 35 m/s). Coal burnout and the release of C and H were observed at the exit of the burner nozzle. Gases such as O2 and CO were measured at the center of the burner. A change in resistance was obtained within the burner.

Suggested Citation

  • Liu, Chunlong & Li, Zhengqi & Kong, Weiguang & Zhao, Yang & Chen, Zhichao, 2010. "Bituminous coal combustion in a full-scale start-up ignition burner: Influence of the excess air ratio," Energy, Elsevier, vol. 35(10), pages 4102-4106.
    • Handle: RePEc:eee:energy:v:35:y:2010:i:10:p:4102-4106
    DOI: 10.1016/j.energy.2010.06.023
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544210003464
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2010.06.023?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Schaffel-Mancini, Natalia & Mancini, Marco & Szlek, Andrzej & Weber, Roman, 2010. "Novel conceptual design of a supercritical pulverized coal boiler utilizing high temperature air combustion (HTAC) technology," Energy, Elsevier, vol. 35(7), pages 2752-2760.
    2. Qi, L.Z. & ZhiXin, W. & Rui, S. & ShaoZeng, S. & LiZhe, C. & ShaoHua, W. & YuKun, Q., 2002. "Influence of division cone angles between the fuel-rich and the fuel-lean ducts on gas–particle flow and combustion near swirl burners," Energy, Elsevier, vol. 27(12), pages 1119-1130.
    3. Liszka, M. & Ziębik, A., 2010. "Coal-fired oxy-fuel power unit – Process and system analysis," Energy, Elsevier, vol. 35(2), pages 943-951.
    4. Fan, Weidong & Li, Youyi & Lin, Zhengchun & Zhang, Mingchuan, 2010. "PDA research on a novel pulverized coal combustion technology for a large utility boiler," Energy, Elsevier, vol. 35(5), pages 2141-2148.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Zeng, Guang & Xu, Mingchen & Tu, Yaojie & Li, Zhenwei & Cai, Yongtie & Zheng, Zhimin & Tay, Kunlin & Yang, Wenming, 2020. "Influences of initial coal concentration on ignition behaviors of low-NOx bias combustion technology," Applied Energy, Elsevier, vol. 278(C).
    2. Dios, M. & Souto, J.A. & Casares, J.J., 2013. "Experimental development of CO2, SO2 and NOx emission factors for mixed lignite and subbituminous coal-fired power plant," Energy, Elsevier, vol. 53(C), pages 40-51.
    3. Li, Zixiang & Miao, Zhengqing & Shen, Xusheng & Li, Jiangtao, 2018. "Effects of momentum ratio and velocity difference on combustion performance in lignite-fired pulverized boiler," Energy, Elsevier, vol. 165(PA), pages 825-839.
    4. Wang, Qingxiang & Chen, Zhichao & Li, Liankai & Zeng, Lingyan & Li, Zhengqi, 2020. "Achievement in ultra-low-load combustion stability for an anthracite- and down-fired boiler after applying novel swirl burners: From laboratory experiments to industrial applications," Energy, Elsevier, vol. 192(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zeng, Lingyan & Li, Zhengqi & Zhao, Guangbo & Li, Jing & Zhang, Fucheng & Shen, Shanping & Chen, Lizhe, 2011. "The influence of swirl burner structure on the gas/particle flow characteristics," Energy, Elsevier, vol. 36(10), pages 6184-6194.
    2. Jing, Jianping & Li, Zhengqi & Zhu, Qunyi & Chen, Zhichao & Wang, Lin & Chen, Lizhe, 2011. "Influence of the outer secondary air vane angle on the gas/particle flow characteristics near the double swirl flow burner region," Energy, Elsevier, vol. 36(1), pages 258-267.
    3. Ren, Feng & Li, Zhengqi & Liu, Guangkui & Chen, Zhichao & Zhu, Qunyi, 2011. "Combustion and NOx emissions characteristics of a down-fired 660-MWe utility boiler retro-fitted with air-surrounding-fuel concept," Energy, Elsevier, vol. 36(1), pages 70-77.
    4. Jing, Jianping & Li, Zhengqi & Wang, Lin & Chen, Lizhe & Yang, Guohua, 2011. "Influence of secondary air mass flow rates on gas/particle flow characteristics near the swirl burner region," Energy, Elsevier, vol. 36(5), pages 3599-3605.
    5. Mi, Jianchun & Li, Pengfei & Zheng, Chuguang, 2011. "Impact of injection conditions on flame characteristics from a parallel multi-jet burner," Energy, Elsevier, vol. 36(11), pages 6583-6595.
    6. Zhang, Xin & Chen, Zhichao & Hou, Jian & Liu, Zheng & Zeng, Lingyan & Li, Zhengqi, 2022. "Evaluation of wide-range coal combustion performance of a novel down-fired combustion technology based on gas–solid two-phase flow characteristics," Energy, Elsevier, vol. 248(C).
    7. Tu, Yaojie & Xu, Shunta & Xu, Mingchen & Liu, Hao & Yang, Wenming, 2020. "Numerical study of methane combustion under moderate or intense low-oxygen dilution regime at elevated pressure conditions up to 8 atm," Energy, Elsevier, vol. 197(C).
    8. Liu, Chunlong & Li, Zhengqi & Zeng, Lingyan & Zhang, Qinghua & Hu, Richa & Zhang, Xusheng & Guo, Liang & Huang, Yong & Yang, Xianwei & Chen, Liheng, 2016. "Gas/particle two-phase flow characteristics of a down-fired 350 MWe supercritical utility boiler at different tertiary air ratios," Energy, Elsevier, vol. 102(C), pages 54-64.
    9. Fang, Neng & Li, Zhengqi & Xie, Cheng & Liu, Shuxuan & Lu, Yue & Zeng, Lingyan & Chen, Zhichao, 2021. "Influence of the multi-burner bias angle on the air/particle flow characteristics in an improved fly ash entrained-flow gasifier," Energy, Elsevier, vol. 234(C).
    10. Yang, D.L. & Tang, G.H. & Fan, Y.H. & Li, X.L. & Wang, S.Q., 2020. "Arrangement and three-dimensional analysis of cooling wall in 1000 MW S–CO2 coal-fired boiler," Energy, Elsevier, vol. 197(C).
    11. Szewczyk, Dariusz & Ślefarski, Rafał & Jankowski, Radosław, 2017. "Analysis of the combustion process of syngas fuels containing high hydrocarbons and nitrogen compounds in Zonal Volumetric Combustion technology," Energy, Elsevier, vol. 121(C), pages 716-725.
    12. Riaza, J. & Álvarez, L. & Gil, M.V. & Pevida, C. & Pis, J.J. & Rubiera, F., 2011. "Effect of oxy-fuel combustion with steam addition on coal ignition and burnout in an entrained flow reactor," Energy, Elsevier, vol. 36(8), pages 5314-5319.
    13. Lin Boqiang & Kui Liu, 2017. "Using LMDI to Analyze the Decoupling of Carbon Dioxide Emissions from China’s Heavy Industry," Sustainability, MDPI, vol. 9(7), pages 1-16, July.
    14. Kuang, Yucheng & He, Boshu & Tong, Wenxiao & Wang, Chaojun & Ying, Zhaoping, 2020. "Effects of oxygen concentration and inlet velocity on pulverized coal MILD combustion," Energy, Elsevier, vol. 198(C).
    15. Fan, Weidong & Lin, Zhengchun & Li, Youyi & Zhang, Mingchuan, 2010. "Experimental flow field characteristics of OFA for large-angle counter flow of fuel-rich jet combustion technology," Applied Energy, Elsevier, vol. 87(8), pages 2737-2745, August.
    16. Adamczyk, Wojciech P. & Bialecki, Ryszard A. & Ditaranto, Mario & Gladysz, Pawel & Haugen, Nils Erland L. & Katelbach-Wozniak, Anna & Klimanek, Adam & Sladek, Slawomir & Szlek, Andrzej & Wecel, Gabrie, 2017. "CFD modeling and thermodynamic analysis of a concept of a MILD-OXY combustion large scale pulverized coal boiler," Energy, Elsevier, vol. 140(P1), pages 1305-1315.
    17. Gładysz, Paweł & Stanek, Wojciech & Czarnowska, Lucyna & Sładek, Sławomir & Szlęk, Andrzej, 2018. "Thermo-ecological evaluation of an integrated MILD oxy-fuel combustion power plant with CO2 capture, utilisation, and storage – A case study in Poland," Energy, Elsevier, vol. 144(C), pages 379-392.
    18. Wang, Qingxiang & Chen, Zhichao & Li, Liankai & Zeng, Lingyan & Li, Zhengqi, 2020. "Achievement in ultra-low-load combustion stability for an anthracite- and down-fired boiler after applying novel swirl burners: From laboratory experiments to industrial applications," Energy, Elsevier, vol. 192(C).
    19. Kotowicz, Janusz & Michalski, Sebastian, 2014. "Efficiency analysis of a hard-coal-fired supercritical power plant with a four-end high-temperature membrane for air separation," Energy, Elsevier, vol. 64(C), pages 109-119.
    20. Cai, Yongtie & Tay, Kunlin & Zheng, Zhimin & Yang, Wenming & Wang, Hui & Zeng, Guang & Li, Zhiwang & Keng Boon, Siah & Subbaiah, Prabakaran, 2018. "Modeling of ash formation and deposition processes in coal and biomass fired boilers: A comprehensive review," Applied Energy, Elsevier, vol. 230(C), pages 1447-1544.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:35:y:2010:i:10:p:4102-4106. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.