IDEAS home Printed from https://ideas.repec.org/a/gam/jagris/v13y2023i5p1059-d1147448.html
   My bibliography  Save this article

Research on the Flexible Heating Model of an Air-Source Heat Pump System in Nursery Pig Houses

Author

Listed:
  • Hua Wang

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Jijun Liu

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Zhonghong Wu

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Jia Liu

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Lu Yi

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Yixue Li

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Siqi Li

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

  • Meizhi Wang

    (College of Animal Science and Technology, China Agricultural University, Beijing 100193, China)

Abstract

Maximizing the utilization of renewable energy for heating is crucial for reducing energy consumption in pig houses and enhancing energy efficiency. However, the mismatch between peak solar radiation and peak heat load demand in nursery pig houses results in energy waste. Therefore, we investigated a flexible air-source heat pump system (F-ASHP) based on the hourly-scale energy transfer of solar energy. A theoretical calculation model for F-ASHPs in pig houses in the heating areas of northern China has been established through on-site testing and Simulink. This study investigated the heat storage and release of four energy storage materials in pens and the variation in heat load in the house, validating the accuracy of the model. The results show that the F-ASHP can effectively match the peak solar heat and peak heat load in the house. Among the four energy storage materials in pens, the magnesium oxide heat storage brick material performed the best. During intermittent solar periods, it released 3319.20 kJ of heat, reducing the heat load in the pig house by 10.1% compared with that by the air-source heat pump (ASHP). This study provides a theoretical model for flexible heating calculations in pig houses in northern China and aims to serve as a valuable resource for selecting energy-storage pens.

Suggested Citation

  • Hua Wang & Jijun Liu & Zhonghong Wu & Jia Liu & Lu Yi & Yixue Li & Siqi Li & Meizhi Wang, 2023. "Research on the Flexible Heating Model of an Air-Source Heat Pump System in Nursery Pig Houses," Agriculture, MDPI, vol. 13(5), pages 1-13, May.
    • Handle: RePEc:gam:jagris:v:13:y:2023:i:5:p:1059-:d:1147448
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2077-0472/13/5/1059/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2077-0472/13/5/1059/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Qiu Tu & Lina Zhang & Linzhang Li & Chenmian Deng & Bingjun Wang & Binquan Gu & Zhengwu Dai, 2022. "Comparison of Application Effects of Capillary Radiation Heat Pump and Electric Heating Wire in Greenhouse Seedling Cultivation," Agriculture, MDPI, vol. 12(9), pages 1-23, September.
    2. Song, Bing & Bai, Lujian & Yang, Liu, 2022. "Analysis of the long-term effects of solar radiation on the indoor thermal comfort in office buildings," Energy, Elsevier, vol. 247(C).
    3. Bansal, Pradeep & Mohabir, Amar & Miller, William, 2016. "A novel method to determine air leakage in heat pump clothes dryers," Energy, Elsevier, vol. 96(C), pages 1-7.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Gluesenkamp, Kyle R. & Boudreaux, Philip & Patel, Viral K. & Goodman, Dakota & Shen, Bo, 2019. "An efficient correlation for heat and mass transfer effectiveness in tumble-type clothes dryer drums," Energy, Elsevier, vol. 172(C), pages 1225-1242.
    2. El Fil, Bachir & Garimella, Srinivas, 2021. "Waste heat recovery in commercial gas-fired tumble dryers," Energy, Elsevier, vol. 218(C).
    3. Jutta Hollands & Eldira Sesto & Azra Korjenic, 2022. "Thermal Comfort in a Greened Office Building: Investigation and Evaluation through Measurement and Survey," Sustainability, MDPI, vol. 14(21), pages 1-27, November.
    4. Rashad, Magdi & Żabnieńska-Góra, Alina & Norman, Les & Jouhara, Hussam, 2022. "Analysis of energy demand in a residential building using TRNSYS," Energy, Elsevier, vol. 254(PB).
    5. Zhixing Li & Mimi Tian & Xiaoqing Zhu & Shujing Xie & Xin He, 2022. "A Review of Integrated Design Process for Building Climate Responsiveness," Energies, MDPI, vol. 15(19), pages 1-35, September.
    6. Czopek, Dorota & Gryboś, Dominik & Leszczyński, Jacek & Wiciak, Jerzy, 2022. "Identification of energy wastes through sound analysis in compressed air systems," Energy, Elsevier, vol. 239(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jagris:v:13:y:2023:i:5:p:1059-:d:1147448. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.