IDEAS home Printed from https://ideas.repec.org/a/eee/renene/v135y2019icp701-710.html
   My bibliography  Save this article

Performance improvement of baffle-type solar air collector based on first chamber narrowing

Author

Listed:
  • Hu, Jianjun
  • Liu, Kaitong
  • Guo, Meng
  • Zhang, Guangqiu
  • Chu, Zhongliang
  • Wang, Meida

Abstract

This paper proposes a novel idea to optimize thermal performance of baffle-type solar air collector by narrowing the first chamber through rearranging the baffles in the collector. The collector with five chambers divided by four baffles was investigated numerically and experimentally, and the mechanism of performance improvement was revealed by flow and heat transfer analysis. The simulation results show that the width of first chamber has significant influence on thermal efficiency, while has little influence on pressure drop. The maximum thermal-efficiency growth rate can be achieved when the width of the first chamber is 200 mm with the total chamber size of 2000 mm × 1000 mm × 120 mm, and the value is up to 16.90% compared with the model with evenly distributed baffles during the Reynolds number ranges from 1.8–5.5 × 103. A test rig was developed at the ratio of 1:0.5 to the numerical model. Four collector models were studied under three working conditions, and effectiveness of this method is verified. The results show that the first-chamber narrowing method has relatively stable optimization effect with a thermal-efficiency growth rate ranges from 9.73% to 16.10% in the experiment. It means that this method is not sensitive to scale change and has certain adaptability.

Suggested Citation

  • Hu, Jianjun & Liu, Kaitong & Guo, Meng & Zhang, Guangqiu & Chu, Zhongliang & Wang, Meida, 2019. "Performance improvement of baffle-type solar air collector based on first chamber narrowing," Renewable Energy, Elsevier, vol. 135(C), pages 701-710.
    • Handle: RePEc:eee:renene:v:135:y:2019:i:c:p:701-710
    DOI: 10.1016/j.renene.2018.12.049
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0960148118314800
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.renene.2018.12.049?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Gulcimen, Fevzi & Karakaya, Hakan & Durmus, Aydın, 2016. "Drying of sweet basil with solar air collectors," Renewable Energy, Elsevier, vol. 93(C), pages 77-86.
    2. Gorji, Tahereh B. & Ranjbar, A.A., 2017. "A review on optical properties and application of nanofluids in direct absorption solar collectors (DASCs)," Renewable and Sustainable Energy Reviews, Elsevier, vol. 72(C), pages 10-32.
    3. Ben-Amara, Mahmoud & Houcine, Imed & Guizani, Aman-Allah & Maalej, Mohammed, 2005. "Efficiency investigation of a new-design air solar plate collector used in a humidification–dehumidification desalination process," Renewable Energy, Elsevier, vol. 30(9), pages 1309-1327.
    4. Ammari, H.D., 2003. "A mathematical model of thermal performance of a solar air heater with slats," Renewable Energy, Elsevier, vol. 28(10), pages 1597-1615.
    5. Karsli, Suleyman, 2007. "Performance analysis of new-design solar air collectors for drying applications," Renewable Energy, Elsevier, vol. 32(10), pages 1645-1660.
    6. Ravi, Ravi Kant & Saini, R.P., 2016. "Experimental investigation on performance of a double pass artificial roughened solar air heater duct having roughness elements of the combination of discrete multi V shaped and staggered ribs," Energy, Elsevier, vol. 116(P1), pages 507-516.
    7. Prasad, K. & Mullick, S. C., 1983. "Heat transfer characteristics of a solar air heater used for drying purposes," Applied Energy, Elsevier, vol. 13(2), pages 83-93, February.
    8. Ho, Chii-Dong & Chang, Hsuan & Wang, Rei-Chi & Lin, Chun-Sheng, 2012. "Performance improvement of a double-pass solar air heater with fins and baffles under recycling operation," Applied Energy, Elsevier, vol. 100(C), pages 155-163.
    9. Fan, Wenke & Kokogiannakis, Georgios & Ma, Zhenjun & Cooper, Paul, 2017. "Development of a dynamic model for a hybrid photovoltaic thermal collector – Solar air heater with fins," Renewable Energy, Elsevier, vol. 101(C), pages 816-834.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Tuncer, Azim Doğuş & Khanlari, Ataollah, 2023. "Improving the performance of a triple-flow solar air collector using recyclable aluminum cans as extended heat transfer surfaces: An energetic, exergetic, economic and environmental survey," Energy, Elsevier, vol. 282(C).
    2. Hu, Jianjun & Zhang, Guangqiu & Zhu, Qing & Guo, Meng & Chen, Lijuan, 2019. "A self-driven mechanical ventilated solar air collector: Design and experimental study," Energy, Elsevier, vol. 189(C).
    3. Afshari, Faraz & Sözen, Adnan & Khanlari, Ataollah & Tuncer, Azim Doğuş & Şirin, Ceylin, 2020. "Effect of turbulator modifications on the thermal performance of cost-effective alternative solar air heater," Renewable Energy, Elsevier, vol. 158(C), pages 297-310.
    4. Hu, Jianjun & Guo, Meng & Guo, Jinyong & Zhang, Guangqiu & Zhang, Yuwen, 2020. "Numerical and experimental investigation of solar air collector with internal swirling flow," Renewable Energy, Elsevier, vol. 162(C), pages 2259-2271.
    5. Vengadesan, Elumalai & Senthil, Ramalingam, 2020. "A review on recent developments in thermal performance enhancement methods of flat plate solar air collector," Renewable and Sustainable Energy Reviews, Elsevier, vol. 134(C).
    6. Bezbaruah, Parag Jyoti & Das, Rajat Subhra & Sarkar, Bikash Kumar, 2021. "Experimental and numerical analysis of solar air heater accoutered with modified conical vortex generators in a staggered fashion," Renewable Energy, Elsevier, vol. 180(C), pages 109-131.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Hu, Jianjun & Guo, Meng & Guo, Jinyong & Zhang, Guangqiu & Zhang, Yuwen, 2020. "Numerical and experimental investigation of solar air collector with internal swirling flow," Renewable Energy, Elsevier, vol. 162(C), pages 2259-2271.
    2. Oztop, Hakan F. & Bayrak, Fatih & Hepbasli, Arif, 2013. "Energetic and exergetic aspects of solar air heating (solar collector) systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 21(C), pages 59-83.
    3. Fudholi, Ahmad & Sopian, Kamaruzzaman, 2019. "A review of solar air flat plate collector for drying application," Renewable and Sustainable Energy Reviews, Elsevier, vol. 102(C), pages 333-345.
    4. Debnath, Suman & Das, Biplab & Randive, P.R. & Pandey, K.M., 2018. "Performance analysis of solar air collector in the climatic condition of North Eastern India," Energy, Elsevier, vol. 165(PB), pages 281-298.
    5. Saini, Raj Kumar & Saini, Devender Kumar & Gupta, Rajeev & Verma, Piush & Thakur, Robin & Kumar, Sushil & wassouf, Ali, 2023. "Technological development in solar dryers from 2016 to 2021-A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 188(C).
    6. Hassan, Hamdy & Abo-Elfadl, Saleh, 2018. "Experimental study on the performance of double pass and two inlet ports solar air heater (SAH) at different configurations of the absorber plate," Renewable Energy, Elsevier, vol. 116(PA), pages 728-740.
    7. Li, Bojia & You, Shijun & Ye, Tianzhen & Zhang, Huan & Li, Xianli & Li, Chao, 2014. "Mathematical modeling and experimental verification of vacuum glazed transpired solar collector with slit-like perforations," Renewable Energy, Elsevier, vol. 69(C), pages 43-49.
    8. Kumar, Anil & Kim, Man-Hoe, 2016. "Thermohydraulic performance of rectangular ducts with different multiple V-rib roughness shapes: A comprehensive review and comparative study," Renewable and Sustainable Energy Reviews, Elsevier, vol. 54(C), pages 635-652.
    9. Gawande, Vipin B. & Dhoble, A.S. & Zodpe, D.B., 2014. "Effect of roughness geometries on heat transfer enhancement in solar thermal systems – A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 32(C), pages 347-378.
    10. Singh, Satyender & Dhiman, Prashant, 2016. "Thermal performance of double pass packed bed solar air heaters – A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 53(C), pages 1010-1031.
    11. Varun Pratap Singh & Siddharth Jain & Ashish Karn & Ashwani Kumar & Gaurav Dwivedi & Chandan Swaroop Meena & Nitesh Dutt & Aritra Ghosh, 2022. "Recent Developments and Advancements in Solar Air Heaters: A Detailed Review," Sustainability, MDPI, vol. 14(19), pages 1-55, September.
    12. Lingayat, Abhay Bhanudas & Chandramohan, V.P. & Raju, V.R.K. & Meda, Venkatesh, 2020. "A review on indirect type solar dryers for agricultural crops – Dryer setup, its performance, energy storage and important highlights," Applied Energy, Elsevier, vol. 258(C).
    13. Yadav, Anil Singh & Bhagoria, J.L., 2013. "Heat transfer and fluid flow analysis of solar air heater: A review of CFD approach," Renewable and Sustainable Energy Reviews, Elsevier, vol. 23(C), pages 60-79.
    14. Kabeel, A.E. & Hamed, Mofreh H. & Omara, Z.M. & Kandeal, A.W., 2017. "Solar air heaters: Design configurations, improvement methods and applications – A detailed review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 70(C), pages 1189-1206.
    15. Cho, Honghyun, 2015. "Comparative study on the performance and exergy efficiency of a solar hybrid heat pump using R22 and R744," Energy, Elsevier, vol. 93(P2), pages 1267-1276.
    16. Qin, Caiyan & Kim, Joong Bae & Lee, Bong Jae, 2019. "Performance analysis of a direct-absorption parabolic-trough solar collector using plasmonic nanofluids," Renewable Energy, Elsevier, vol. 143(C), pages 24-33.
    17. Youcef-Ali, S. & Desmons, J.Y., 2006. "Numerical and experimental study of a solar equipped with offset rectangular plate fin absorber plate," Renewable Energy, Elsevier, vol. 31(13), pages 2063-2075.
    18. Chii-Dong Ho & Hsuan Chang & Ching-Fang Hsiao & Chien-Chang Huang, 2018. "Device Performance Improvement of Recycling Double-Pass Cross-Corrugated Solar Air Collectors," Energies, MDPI, vol. 11(2), pages 1-18, February.
    19. Youcef-Ali, S. & Desmons, J.Y., 2007. "Influence of the aerothermic parameters and the product quantity on the production capacity of an indirect solar dryer," Renewable Energy, Elsevier, vol. 32(3), pages 496-511.
    20. Vengadesan, Elumalai & Senthil, Ramalingam, 2020. "A review on recent developments in thermal performance enhancement methods of flat plate solar air collector," Renewable and Sustainable Energy Reviews, Elsevier, vol. 134(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:renene:v:135:y:2019:i:c:p:701-710. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/renewable-energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.