IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v8y2015i6p5440-5458d50766.html
   My bibliography  Save this article

Next Generation Solar Cells Based on Graded Bandgap Device Structures Utilising Rod-Type Nano-Materials

Author

Listed:
  • Imyhamy M. Dharmadasa

    (Materials and Engineering Research Institute, Sheffield Hallam University, Sheffield S1 1WB, UK)

  • Ayotunde A. Ojo

    (Materials and Engineering Research Institute, Sheffield Hallam University, Sheffield S1 1WB, UK)

  • Hussein I. Salim

    (Materials and Engineering Research Institute, Sheffield Hallam University, Sheffield S1 1WB, UK)

  • Ruvini Dharmadasa

    (Conn Centre for Renewable Energy Research, University of Louiseville, Kentucky, KY 40292, USA)

Abstract

Current solar cells under research and development utilise mainly one absorber layer limiting the photon harvesting capabilities. In order to develop next generation solar cells, research should move towards effective photon harvesting methods utilising low-cost solar energy materials. This will lead to reduce the $W −1 figure for direct solar energy conversion to electrical energy. In this work, a graded bandgap solar cell has been designed to absorb all photons from the UV, visible and IR regions. In addition, impurity PV effect and impact ionisation have been incorporated to enhance charge carrier creation within the same device. This new design has been experimentally tested using the most researched MOCVD grown GaAs/AlGaAs system, in order to confirm its validity. Devices with high V oc ~ 1175 mV and the highest possible FF ~ (0.85–0.87) have been produced, increasing the conversion efficiency to ~20% within only two growth runs. These devices were also experimentally tested for the existence of impurity PV effect and impact ionisation. The devices are PV active in complete darkness producing over 800 mV, V oc indicating the harvesting of IR radiation from the surroundings through impurity PV effect. The quantum efficiency measurements show over 140% signal confirming the contribution to PV action from impact ionisation. Since the concept is successfully proven, the low-cost and scalable electrodeposited semiconducting layers are used to produce graded bandgap solar cell structures. The utilisation of nano- and micro-rod type materials in graded bandgap devices are also presented and discussed in this paper. Preliminary work on glass/FTO/n-ZnS/n-CdS/n-CdTe/Au graded bandgap devices show 10%–12% efficient devices indicating extremely high J sc values ~48 mA·cm −2 , showing the high potential of these devices in achieving higher efficiencies. The detailed results on these low-cost and novel graded bandgap devices are presented in a separate publication.

Suggested Citation

  • Imyhamy M. Dharmadasa & Ayotunde A. Ojo & Hussein I. Salim & Ruvini Dharmadasa, 2015. "Next Generation Solar Cells Based on Graded Bandgap Device Structures Utilising Rod-Type Nano-Materials," Energies, MDPI, vol. 8(6), pages 1-19, June.
    • Handle: RePEc:gam:jeners:v:8:y:2015:i:6:p:5440-5458:d:50766
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/8/6/5440/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/8/6/5440/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Obi K. Echendu & Imyhamy M. Dharmadasa, 2015. "Graded-Bandgap Solar Cells Using All-Electrodeposited ZnS, CdS and CdTe Thin-Films," Energies, MDPI, vol. 8(5), pages 1-20, May.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Ogbomo, Osarumen O. & Amalu, Emeka H. & Ekere, N.N. & Olagbegi, P.O., 2017. "A review of photovoltaic module technologies for increased performance in tropical climate," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 1225-1238.
    2. Obi K. Echendu & Imyhamy M. Dharmadasa, 2015. "Graded-Bandgap Solar Cells Using All-Electrodeposited ZnS, CdS and CdTe Thin-Films," Energies, MDPI, vol. 8(5), pages 1-20, May.
    3. I. M. Dharmadasa & A. E. Alam, 2022. "How to Achieve Efficiencies beyond 22.1% for CdTe-Based Thin-Film Solar Cells," Energies, MDPI, vol. 15(24), pages 1-23, December.
    4. Mohamed Derbeli & Cristian Napole & Oscar Barambones & Jesus Sanchez & Isidro Calvo & Pablo Fernández-Bustamante, 2021. "Maximum Power Point Tracking Techniques for Photovoltaic Panel: A Review and Experimental Applications," Energies, MDPI, vol. 14(22), pages 1-31, November.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.

      Corrections

      All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:8:y:2015:i:6:p:5440-5458:d:50766. See general information about how to correct material in RePEc.

      If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

      If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

      If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

      For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

      Please note that corrections may take a couple of weeks to filter through the various RePEc services.

      IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.