IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i4p1176-d503893.html
   My bibliography  Save this article

Assessment of Indoor Air Parameters in Building Equipped with Decentralised Façade Ventilation Device

Author

Listed:
  • Ewa Zender–Świercz

    (Department of Building Physics and Renewable Energy, Faculty of Environmental, Geomatic and Energy Engineering, Kielce University of Technology, 25-314 Kielce, Poland)

Abstract

The study contains an analysis of a decentralised unit installed in a building façade, where air supply and exhaust cycles are swapped by proper positioning of dampers. The analysis was carried out in real conditions in an office building. The Computational Fluid Dynamics (CFD) simulation is an important element of the system design, and has become more and more widely used. Simulation of the analysed unit has shown air stream distribution in a room. Moreover, it allowed for determination of indoor air temperature. Completed analysis and CFD simulations allow for the observation that façade ventilation systems provide a good way to improve the indoor microclimate, as they effectively reduce air pollution. The decentralised façade ventilation unit reduced the carbon dioxide concentration to a level lower than 1000 ppm and maintained the indoor air temperature in the range of 19.5–22 °C. The error for CFD simulation equals 0.5%, which is not much. The results of research and analysis show that the highest reduction of carbon dioxide concentration occurred when supply/exhaust time equalled 10 min. At the same time, when supply/exhaust time equalled 10 min, the indoor air temperature was the lowest of the recorded values.

Suggested Citation

  • Ewa Zender–Świercz, 2021. "Assessment of Indoor Air Parameters in Building Equipped with Decentralised Façade Ventilation Device," Energies, MDPI, vol. 14(4), pages 1-16, February.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:4:p:1176-:d:503893
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/4/1176/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/4/1176/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Belen Moreno Santamaria & Fernando del Ama Gonzalo & Danielle Pinette & Roberto-Alonso Gonzalez-Lezcano & Benito Lauret Aguirregabiria & Juan A. Hernandez Ramos, 2020. "Application and Validation of a Dynamic Energy Simulation Tool: A Case Study with Water Flow Glazing Envelope," Energies, MDPI, vol. 13(12), pages 1-20, June.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Belen Moreno Santamaria & Fernando del Ama Gonzalo & Benito Lauret Aguirregabiria & Juan A. Hernandez Ramos, 2020. "Experimental Validation of Water Flow Glazing: Transient Response in Real Test Rooms," Sustainability, MDPI, vol. 12(14), pages 1-24, July.
    2. Belen Moreno Santamaria & Fernando del Ama Gonzalo & Matthew Griffin & Benito Lauret Aguirregabiria & Juan A. Hernandez Ramos, 2021. "Life Cycle Assessment of Dynamic Water Flow Glazing Envelopes: A Case Study with Real Test Facilities," Energies, MDPI, vol. 14(8), pages 1-17, April.
    3. Lin He & Shunan Zhao & Guowen Xu & Xin Wu & Junlong Xie & Shanshan Cai, 2021. "Prediction and Evaluation of Dynamic Variations of the Thermal Environment in an Air-Conditioned Room Using Collaborative Simulation Method," Energies, MDPI, vol. 14(17), pages 1-19, August.
    4. Fernando del Ama Gonzalo & Belen Moreno Santamaria & José Antonio Ferrándiz Gea & Matthew Griffin & Juan A. Hernandez Ramos, 2021. "Zero Energy Building Economic and Energetic Assessment with Simulated and Real Data Using Photovoltaics and Water Flow Glazing," Energies, MDPI, vol. 14(11), pages 1-20, June.
    5. Fernando del Ama Gonzalo & Belén Moreno Santamaría & Juan A. Hernández Ramos, 2022. "Assessment of Water Flow Glazing as Building-Integrated Solar Thermal Collector," Sustainability, MDPI, vol. 15(1), pages 1-21, December.
    6. Belen Moreno Santamaria & Fernando del Ama Gonzalo & Danielle Pinette & Benito Lauret Aguirregabiria & Juan A. Hernandez Ramos, 2020. "Industrialization and Thermal Performance of a New Unitized Water Flow Glazing Facade," Sustainability, MDPI, vol. 12(18), pages 1-22, September.
    7. Belen Moreno Santamaria & Fernando del Ama Gonzalo & Benito Lauret Aguirregabiria & Juan A. Hernandez Ramos, 2020. "Evaluation of Thermal Comfort and Energy Consumption of Water Flow Glazing as a Radiant Heating and Cooling System: A Case Study of an Office Space," Sustainability, MDPI, vol. 12(18), pages 1-27, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:4:p:1176-:d:503893. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.