IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i6p1452-d334722.html
   My bibliography  Save this article

Investigation of the Effects of Plasma Discharges on Methane Decomposition for Combustion Enhancement of a Lean Flame

Author

Listed:
  • Maria Grazia De Giorgi

    (Department of Engineering for Innovation, University of Salento, via per Monteroni, I-73100 Lecce, Italy)

  • Antonio Ficarella

    (Department of Engineering for Innovation, University of Salento, via per Monteroni, I-73100 Lecce, Italy)

  • Donato Fontanarosa

    (Department of Engineering for Innovation, University of Salento, via per Monteroni, I-73100 Lecce, Italy)

  • Elisa Pescini

    (Department of Engineering for Innovation, University of Salento, via per Monteroni, I-73100 Lecce, Italy)

  • Antonio Suma

    (Department of Engineering for Innovation, University of Salento, via per Monteroni, I-73100 Lecce, Italy)

Abstract

The present work focuses on the impact of dielectric barrier discharge (DBD) plasma actuators (PAs) on non-premixed lifted flame stabilization in a methane CH 4 -air Bunsen burner. Two coaxial DBD-PA configurations are considered. They are composed of a copper corona, installed on the outer surface of a quartz tube and powered with a high voltage sinusoidal signal, and a grounded needle installed along the burner axis. The two configurations differ in the standoff distance value, which indicates the positioning of the high frequency/high voltage (HV) electrode’s upper edge with respect to the needle tip. Experimental results highlight that flame reattachment is obtained at a lower dissipated power when using a negative standoff distance (i.e., placing the needle upstream with respect to the corona). At 11 kV peak-to-peak voltage and 20 kHz frequency, plasma actuation allowed for reattaching the flame with a very low dissipated power (of about 0.05 W). Numerical simulations of the electrostatic field confirmed that this negative standoff configuration has a beneficial effect on the momentum sources, which oppose the flow and show that the highest electric field extends into the inner quartz tube, as confirmed by experimental visualization close to the needle tip. The modeling predicted an increase in the gas temperature of about 21.8 °C and a slight modification of the fuel composition at the burner exit. This impacts the flame speed with a 10% increase close to the stoichiometric conditions with respect to the clean configuration.

Suggested Citation

  • Maria Grazia De Giorgi & Antonio Ficarella & Donato Fontanarosa & Elisa Pescini & Antonio Suma, 2020. "Investigation of the Effects of Plasma Discharges on Methane Decomposition for Combustion Enhancement of a Lean Flame," Energies, MDPI, vol. 13(6), pages 1-19, March.
    • Handle: RePEc:gam:jeners:v:13:y:2020:i:6:p:1452-:d:334722
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/6/1452/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/13/6/1452/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Oh, Jeongseog & Noh, Dongsoon, 2015. "Flame characteristics of a non-premixed oxy-fuel jet in a lab-scale furnace," Energy, Elsevier, vol. 81(C), pages 328-343.
    2. Baigmohammadi, Mohammadreza & Tabejamaat, Sadegh & Zarvandi, Jalal, 2015. "Numerical study of the behavior of methane-hydrogen/air pre-mixed flame in a micro reactor equipped with catalytic segmented bluff body," Energy, Elsevier, vol. 85(C), pages 117-144.
    3. Choi, Sun & Lee, Seungro & Kwon, Oh Chae, 2015. "Extinction limits and structure of counterflow nonpremixed hydrogen-doped ammonia/air flames at elevated temperatures," Energy, Elsevier, vol. 85(C), pages 503-510.
    4. Lee, Seungro & Padilla, Rosa & Dunn-Rankin, Derek & Pham, Trinh & Kwon, Oh Chae, 2015. "Extinction limits and structure of counterflow nonpremixed H2O-laden CH4/air flames," Energy, Elsevier, vol. 93(P1), pages 442-450.
    5. Yu-Chien Chien & Derek Dunn-Rankin, 2018. "Electric Field Induced Changes of a Diffusion Flame and Heat Transfer near an Impinging Surface," Energies, MDPI, vol. 11(5), pages 1-13, May.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Ghazanfar Mehdi & Sara Bonuso & Maria Grazia De Giorgi, 2021. "Effects of Nanosecond Repetitively Pulsed Discharges Timing for Aeroengines Ignition at Low Temperature Conditions by Needle-Ring Plasma Actuator," Energies, MDPI, vol. 14(18), pages 1-19, September.
    2. Hookyung Lee & Min-Jung Lee, 2021. "Recent Advances in Ammonia Combustion Technology in Thermal Power Generation System for Carbon Emission Reduction," Energies, MDPI, vol. 14(18), pages 1-29, September.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. De Giorgi, Maria Grazia & Ficarella, Antonio & Sciolti, Aldebara & Pescini, Elisa & Campilongo, Stefano & Di Lecce, Giorgio, 2017. "Improvement of lean flame stability of inverse methane/air diffusion flame by using coaxial dielectric plasma discharge actuators," Energy, Elsevier, vol. 126(C), pages 689-706.
    2. Maria Grazia De Giorgi & Aldebara Sciolti & Stefano Campilongo & Antonio Ficarella, 2017. "Flame Structure and Chemiluminescence Emissions of Inverse Diffusion Flames under Sinusoidally Driven Plasma Discharges," Energies, MDPI, vol. 10(3), pages 1-15, March.
    3. Yuan, Ye & Li, GuoXiu & Sun, ZuoYu & Li, HongMeng & Zhou, ZiHang, 2016. "Experimental study on the dynamical features of a partially premixed methane jet flame in coflow," Energy, Elsevier, vol. 111(C), pages 593-598.
    4. Ku, Jae Won & Choi, Sun & Kim, Hee Kyung & Lee, Seungro & Kwon, Oh Chae, 2018. "Extinction limits and structure of counterflow nonpremixed methane-ammonia/air flames," Energy, Elsevier, vol. 165(PA), pages 314-325.
    5. Olga Gaidukova & Sergei Misyura & Pavel Strizhak, 2022. "Key Areas of Gas Hydrates Study: Review," Energies, MDPI, vol. 15(5), pages 1-18, February.
    6. Cai, Tao & Zhao, Dan & Chan, Siew Hwa & Shahsavari, Mohammad, 2022. "Tailoring reduced mechanisms for predicting flame propagation and ignition characteristics in ammonia and ammonia/hydrogen mixtures," Energy, Elsevier, vol. 260(C).
    7. Lars Zigan, 2018. "Electric Fields in Energy and Process Engineering," Energies, MDPI, vol. 11(9), pages 1-4, August.
    8. Ruirui Wang & Jingyu Ran & Xuesen Du & Juntian Niu & Wenjie Qi, 2016. "The Influence of Slight Protuberances in a Micro-Tube Reactor on Methane/Moist Air Catalytic Combustion," Energies, MDPI, vol. 9(6), pages 1-17, May.
    9. Rashwan, Sherif S. & Ibrahim, Abdelmaged H. & Abou-Arab, Tharwat W. & Nemitallah, Medhat A. & Habib, Mohamed A., 2017. "Experimental study of atmospheric partially premixed oxy-combustion flames anchored over a perforated plate burner," Energy, Elsevier, vol. 122(C), pages 159-167.
    10. Lazaroiu, Gheorghe & Pop, Elena & Negreanu, Gabriel & Pisa, Ionel & Mihaescu, Lucian & Bondrea, Andreya & Berbece, Viorel, 2017. "Biomass combustion with hydrogen injection for energy applications," Energy, Elsevier, vol. 127(C), pages 351-357.
    11. Yang, Ke & Chen, Kaifeng & Ji, Hong & Xing, Zhixiang & Hao, Yongmei & Wu, Jie & Jiang, Juncheng, 2021. "Experimental study on the effect of modified attapulgite powder with different outlet blockage ratios on methane-air explosion," Energy, Elsevier, vol. 237(C).
    12. Ali Alnasif & Syed Mashruk & Masao Hayashi & Joanna Jójka & Hao Shi & Akihiro Hayakawa & Agustin Valera-Medina, 2023. "Performance Investigation of Currently Available Reaction Mechanisms in the Estimation of NO Measurements: A Comparative Study," Energies, MDPI, vol. 16(9), pages 1-30, April.
    13. Yan, Yunfei & Wu, Gange & Huang, Weipeng & Zhang, Li & Li, Lixian & Yang, Zhongqing, 2019. "Numerical comparison study of methane catalytic combustion characteristic between newly proposed opposed counter-flow micro-combustor and the conventional ones," Energy, Elsevier, vol. 170(C), pages 403-410.
    14. Li, Yunlong & Feng, Lai & Chen, Wei, 2024. "Chemical effect of H2 on NH3 combustion in an O2 environment via molecular dynamics simulations," Energy, Elsevier, vol. 308(C).
    15. Liu, Lijuan & Zhang, Qi, 2019. "Flame range and energy output in two-phase propylene oxide/air mixtures beyond the original premixed zone," Energy, Elsevier, vol. 171(C), pages 666-677.
    16. Wan, Jianlong & Fan, Aiwu & Yao, Hong & Liu, Wei, 2016. "Experimental investigation and numerical analysis on the blow-off limits of premixed CH4/air flames in a mesoscale bluff-body combustor," Energy, Elsevier, vol. 113(C), pages 193-203.
    17. Lars Zigan, 2018. "Overview of Electric Field Applications in Energy and Process Engineering," Energies, MDPI, vol. 11(6), pages 1-33, May.
    18. Jiang, Haipeng & Bi, Mingshu & Huang, Lei & Zhou, Yonghao & Gao, Wei, 2022. "Suppression mechanism of ultrafine water mist containing phosphorus compounds in methane/coal dust explosions," Energy, Elsevier, vol. 239(PA).
    19. Alipoor, Alireza & Mazaheri, Kiumars, 2016. "Combustion characteristics and flame bifurcation in repetitive extinction-ignition dynamics for premixed hydrogen-air combustion in a heated micro channel," Energy, Elsevier, vol. 109(C), pages 650-663.
    20. Zuo, Wei & E, Jiaqiang & Hu, Wenyu & Jin, Yu & Han, Dandan, 2017. "Numerical investigations on combustion characteristics of H2/air premixed combustion in a micro elliptical tube combustor," Energy, Elsevier, vol. 126(C), pages 1-12.

    More about this item

    Keywords

    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:6:p:1452-:d:334722. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.