IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i14p5071-d860596.html
   My bibliography  Save this article

Pyrolysis of Chromated Copper Arsenate-Treated Wood: Investigation of Temperature, Granulometry, Biochar Yield, and Metal Pathways

Author

Listed:
  • Mouna Gmar

    (Forest Research Institute, Université du Québec en Abitibi-Témiscamingue, 445 Boul. University, Rouyn-Noranda, QC J9X 5E4, Canada)

  • Hassine Bouafif

    (Centre Technologique des Résidus Industriels (CTRI), Rouyn-Noranda, QC J9X 5E5, Canada)

  • Besma Bouslimi

    (Forest Research Institute, Université du Québec en Abitibi-Témiscamingue, 445 Boul. University, Rouyn-Noranda, QC J9X 5E4, Canada)

  • Flavia L. Braghiroli

    (Forest Research Institute, Université du Québec en Abitibi-Témiscamingue, 445 Boul. University, Rouyn-Noranda, QC J9X 5E4, Canada
    Centre Technologique des Résidus Industriels (CTRI), Rouyn-Noranda, QC J9X 5E5, Canada)

  • Ahmed Koubaa

    (Forest Research Institute, Université du Québec en Abitibi-Témiscamingue, 445 Boul. University, Rouyn-Noranda, QC J9X 5E4, Canada)

Abstract

Chromated copper arsenate-treated (cca) wood disposal faces environmental restrictions due to its toxicity, heavy metal leaching in storage sites, and greenhouse gas emissions during incineration. Thus, finding new management methods for this contaminated wood at the end of life is crucial. This study evaluated the effect of pyrolysis temperature (300, 400, and 500 °C), particle size, biochar yield, and the behavior of arsenic (As), chromium (Cr), and copper (Cu) during treated-wood pyrolysis. The highest biochar yield was obtained at 300 °C for fine particles. The biochar retention of heavy metals decreased with increasing pyrolysis temperature. At 300 °C, the highest biochar As, Cr, and Cu retentions were 76, 91, and 83%. At 500 °C, biochar only retained 43% of the As. Additionally, heavy metal leaching from the biochar exceeded the Environmental Protection Agency’s (EPA) maximum concentration limit of 5 mg/L. High-density polyethylene encapsulation of contaminated biochar reduced the leaching of As, Cr, and Cu by 96, 95, and 91%, respectively. Thus, combining pyrolysis and plastic encapsulation to produce a composite material could be a solution for reducing waste (conversion of CCA-wood into biochar) and for the safe disposal of contaminated wood.

Suggested Citation

  • Mouna Gmar & Hassine Bouafif & Besma Bouslimi & Flavia L. Braghiroli & Ahmed Koubaa, 2022. "Pyrolysis of Chromated Copper Arsenate-Treated Wood: Investigation of Temperature, Granulometry, Biochar Yield, and Metal Pathways," Energies, MDPI, vol. 15(14), pages 1-15, July.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:14:p:5071-:d:860596
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/14/5071/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/14/5071/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Van de Velden, Manon & Baeyens, Jan & Brems, Anke & Janssens, Bart & Dewil, Raf, 2010. "Fundamentals, kinetics and endothermicity of the biomass pyrolysis reaction," Renewable Energy, Elsevier, vol. 35(1), pages 232-242.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Primaz, Carmem T. & Ribes-Greus, Amparo & Jacques, Rosângela A., 2021. "Valorization of cotton residues for production of bio-oil and engineered biochar," Energy, Elsevier, vol. 235(C).
    2. Ábrego, J. & Atienza-Martínez, M. & Plou, F. & Arauzo, J., 2019. "Heat requirement for fixed bed pyrolysis of beechwood chips," Energy, Elsevier, vol. 178(C), pages 145-157.
    3. López-González, D. & Puig-Gamero, M. & Acién, F.G. & García-Cuadra, F. & Valverde, J.L. & Sanchez-Silva, L., 2015. "Energetic, economic and environmental assessment of the pyrolysis and combustion of microalgae and their oils," Renewable and Sustainable Energy Reviews, Elsevier, vol. 51(C), pages 1752-1770.
    4. M. N. Uddin & Kuaanan Techato & Juntakan Taweekun & Md Mofijur Rahman & M. G. Rasul & T. M. I. Mahlia & S. M. Ashrafur, 2018. "An Overview of Recent Developments in Biomass Pyrolysis Technologies," Energies, MDPI, vol. 11(11), pages 1-24, November.
    5. Andrew N. Amenaghawon & Chinedu L. Anyalewechi & Charity O. Okieimen & Heri Septya Kusuma, 2021. "Biomass pyrolysis technologies for value-added products: a state-of-the-art review," Environment, Development and Sustainability: A Multidisciplinary Approach to the Theory and Practice of Sustainable Development, Springer, vol. 23(10), pages 14324-14378, October.
    6. Kartal, Furkan & Dalbudak, Yağmur & Özveren, Uğur, 2023. "Prediction of thermal degradation of biopolymers in biomass under pyrolysis atmosphere by means of machine learning," Renewable Energy, Elsevier, vol. 204(C), pages 774-787.
    7. Granada, E. & Eguía, P. & Vilan, J.A. & Comesaña, J.A. & Comesaña, R., 2012. "FTIR quantitative analysis technique for gases. Application in a biomass thermochemical process," Renewable Energy, Elsevier, vol. 41(C), pages 416-421.
    8. Amutio, M. & Lopez, G. & Artetxe, M. & Elordi, G. & Olazar, M. & Bilbao, J., 2012. "Influence of temperature on biomass pyrolysis in a conical spouted bed reactor," Resources, Conservation & Recycling, Elsevier, vol. 59(C), pages 23-31.
    9. Yimin Deng & Renaud Ansart & Jan Baeyens & Huili Zhang, 2019. "Flue Gas Desulphurization in Circulating Fluidized Beds," Energies, MDPI, vol. 12(20), pages 1-19, October.
    10. Juan Luis Aguirre & Juan Baena & María Teresa Martín & Leonor Nozal & Sergio González & José Luis Manjón & Manuel Peinado, 2020. "Composition, Ageing and Herbicidal Properties of Wood Vinegar Obtained through Fast Biomass Pyrolysis," Energies, MDPI, vol. 13(10), pages 1-17, May.
    11. Liu, Hui & Liu, Jingyong & Huang, Hongyi & Evrendilek, Fatih & Wen, Shaoting & Li, Weixin, 2021. "Optimizing bioenergy and by-product outputs from durian shell pyrolysis," Renewable Energy, Elsevier, vol. 164(C), pages 407-418.
    12. Brillard, A. & Brilhac, J.F., 2020. "Improvements of global models for the determination of the kinetic parameters associated to the thermal degradation of lignocellulosic materials under low heating rates," Renewable Energy, Elsevier, vol. 146(C), pages 1498-1509.
    13. Li, Xiangyu & Li, Guangyu & Li, Jian & Yu, Yanqing & Feng, Yu & Chen, Qun & Komarneni, Sridhar & Wang, Yujue, 2016. "Producing petrochemicals from catalytic fast pyrolysis of corn fermentation residual by-products generated from citric acid production," Renewable Energy, Elsevier, vol. 89(C), pages 331-338.
    14. Campuzano, Felipe & Brown, Robert C. & Martínez, Juan Daniel, 2019. "Auger reactors for pyrolysis of biomass and wastes," Renewable and Sustainable Energy Reviews, Elsevier, vol. 102(C), pages 372-409.
    15. Collazo, Joaquín & Pazó, José Antonio & Granada, Enrique & Saavedra, Ángeles & Eguía, Pablo, 2012. "Determination of the specific heat of biomass materials and the combustion energy of coke by DSC analysis," Energy, Elsevier, vol. 45(1), pages 746-752.
    16. Xing, Jiangkuan & Wang, Haiou & Luo, Kun & Wang, Shuai & Bai, Yun & Fan, Jianren, 2019. "Predictive single-step kinetic model of biomass devolatilization for CFD applications: A comparison study of empirical correlations (EC), artificial neural networks (ANN) and random forest (RF)," Renewable Energy, Elsevier, vol. 136(C), pages 104-114.
    17. Görling, Martin & Larsson, Mårten & Alvfors, Per, 2013. "Bio-methane via fast pyrolysis of biomass," Applied Energy, Elsevier, vol. 112(C), pages 440-447.
    18. Zeng, Kuo & Soria, José & Gauthier, Daniel & Mazza, Germán & Flamant, Gilles, 2016. "Modeling of beech wood pellet pyrolysis under concentrated solar radiation," Renewable Energy, Elsevier, vol. 99(C), pages 721-729.
    19. Kardaś, Dariusz & Hercel, Paulina & Wardach-Świȩcicka, Izabela & Polesek-Karczewska, Sylwia, 2021. "On the kinetic rate of biomass particle decomposition - Experimental and numerical analysis," Energy, Elsevier, vol. 219(C).
    20. Siddiqi, Hammad & Kumari, Usha & Biswas, Subrata & Mishra, Asmita & Meikap, B.C., 2020. "A synergistic study of reaction kinetics and heat transfer with multi-component modelling approach for the pyrolysis of biomass waste," Energy, Elsevier, vol. 204(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:14:p:5071-:d:860596. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.