IDEAS home Printed from https://ideas.repec.org/a/wsi/srlxxx/v16y2009i05ns0218625x09013189.html
   My bibliography  Save this article

Dynamics And Topography Of Quasi-2d Needle-Like Silver Electrochemical Deposits Under A Quasi-Steady-State Regime

Author

Listed:
  • M. A. PASQUALE

    (Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicadas (INIFTA), (Universidad Nacional de La Plata-Consejo Nacional de Investigaciones, Científicas y Técnicas), Sucursal 4, Casilla de Correo 16, Argentina)

  • J. L. VICENTE

    (Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicadas (INIFTA), (Universidad Nacional de La Plata-Consejo Nacional de Investigaciones, Científicas y Técnicas), Sucursal 4, Casilla de Correo 16, Argentina)

  • A. J. ARVIA

    (Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicadas (INIFTA), (Universidad Nacional de La Plata-Consejo Nacional de Investigaciones, Científicas y Técnicas), Sucursal 4, Casilla de Correo 16, Argentina)

Abstract

The electrochemical formation of single silver needles from aqueous silver sulfate was studied under both potentiostatic and galvanostatic conditions utilizing different quasi-2D cells. Under potentiostatic conditions, four (I–IV) stages of growth were distinguished. Stage III involved single needle growth under a quasi-steady-state (q-ss) regime in which, at the millimeter scale, the tip profile remained almost unchanged. Fast growing needles exhibited a truncated quasi-conical tip, and slow growing ones approached prolate hemispheroids. At stage III, the almost constant q-ss silver deposition rate was evaluated from the tip front displacement(dLz/dt)perpendicularly to the tangential plane of the tip. For the cathode to anode potential difference in the range-1.00 ≤ Ec-a≤ -0.22V, values of(dLz/dt)in the range 0.08–2.0 μm s-1were obtained. At the needle stem, the q-ss radial silver deposition rate(dLx/dt)was about two orders of magnitude lower than(dLz/dt). The transition from stage III to IV was characterized by tip thickening, i.e. a change in the tip q-conical profile to that of a prolate hemispheroid, and eventual tip splitting. Scanning electron micrographs at the micrometer scale of single silver needle tips from potentiostatic runs showed either a defined crystallography or an irregular topography covered by a large number of tiny crystals. In contrast, stems were always faceted. This difference indicated that surface relaxation processes following silver ion mass transport and discharge played a relevant role in the needle growth mode. At stage III, the growth regime is described utilizing a dual diffusion (D) and migration (M) model consisting of a DM direct contribution that becomes dominant at the needle stem, and a space charge (SC)-assisted DM contribution that operates at the tip apex. This explanation is consistent with the local cathodic current density values, the concentration ratio of silver clusters at the stem and tip apex surface, and the distinct kinetic behavior of needles produced from potentiostatic and galvanostatic runs. The complex link between mass transport phenomena of silver ions from the binary solution side, the silver ion discharge at the interface and the surface relaxation of silver adatoms and clusters at the metal lattice shed new light on the aspects of single silver needle formation.

Suggested Citation

  • M. A. Pasquale & J. L. Vicente & A. J. Arvia, 2009. "Dynamics And Topography Of Quasi-2d Needle-Like Silver Electrochemical Deposits Under A Quasi-Steady-State Regime," Surface Review and Letters (SRL), World Scientific Publishing Co. Pte. Ltd., vol. 16(05), pages 697-713.
  • Handle: RePEc:wsi:srlxxx:v:16:y:2009:i:05:n:s0218625x09013189
    DOI: 10.1142/S0218625X09013189
    as

    Download full text from publisher

    File URL: http://www.worldscientific.com/doi/abs/10.1142/S0218625X09013189
    Download Restriction: Access to full text is restricted to subscribers

    File URL: https://libkey.io/10.1142/S0218625X09013189?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:wsi:srlxxx:v:16:y:2009:i:05:n:s0218625x09013189. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Tai Tone Lim (email available below). General contact details of provider: http://www.worldscinet.com/srl/srl.shtml .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.