Author
Listed:
- M. RUSOP
(Institute of Science, Universiti Teknologi MARA (UiTM), Shah Alam 40450, Selangor, Malaysia)
- S. ABDULLAH
(Institute of Science, Universiti Teknologi MARA (UiTM), Shah Alam 40450, Selangor, Malaysia)
- A. M. M. OMER
(Department of Electronic Engineering, Chubu University, Matsumoto-cho 1200, Kasugai 487-8501, Japan)
- S. ADHIKARI
(Department of Electronic Engineering, Chubu University, Matsumoto-cho 1200, Kasugai 487-8501, Japan)
- T. SOGA
(Department of Environmental Technology and Urban Planning, Nagoya Institute of Technology, Gokiso-cho, Showa-ku, Nagoya 466-8555, Japan)
- T. JIMBO
(Research Center for Nano-Device and System, Nagoya Institute of Technology, Gokiso-cho, Showa-ku, Nagoya 466-8555, Japan)
- M. UMENO
(Department of Electronic Engineering, Chubu University, Matsumoto-cho 1200, Kasugai 487-8501, Japan)
Abstract
We have studied the influence of the methane gas(CH4)flow rate on the composition and structural and electrical properties of nitrogenated amorphous carbon(a-C:N)films grown by surface wave microwave plasma chemical vapor deposition (SWMP-CVD) using Auger electron spectroscopy, X-ray photoelectron spectroscopy, UV-visible spectroscopy, four-point probe and two-probe method resistance measurement. The photoelectrical properties ofa-C:Nfilms were also studied. We have succeeded to growa-C:Nfilms using a novel method of SWMP-CVD at room temperature and found that the deposition rate, bonding and optical and electrical properties ofa-C:Nfilms are strongly dependent on theCH4gas sources, and thea-C:Nfilms grown at higherCH4gas flow rate have relatively high electrical conductivity for both cases of in dark and under illumination condition.
Suggested Citation
M. Rusop & S. Abdullah & A. M. M. Omer & S. Adhikari & T. Soga & T. Jimbo & M. Umeno, 2006.
"Effects Of Methane Gas Flow Rate On The Optoelectrical Properties Of Nitrogenated Carbon Thin Films Grown By Surface Wave Microwave Plasma Chemical Vapor Deposition,"
Surface Review and Letters (SRL), World Scientific Publishing Co. Pte. Ltd., vol. 13(05), pages 585-592.
Handle:
RePEc:wsi:srlxxx:v:13:y:2006:i:05:n:s0218625x06008530
DOI: 10.1142/S0218625X06008530
Download full text from publisher
As the access to this document is restricted, you may want to
for a different version of it.
Corrections
All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:wsi:srlxxx:v:13:y:2006:i:05:n:s0218625x06008530. See general information about how to correct material in RePEc.
If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.
We have no bibliographic references for this item. You can help adding them by using this form .
If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.
For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Tai Tone Lim (email available below). General contact details of provider: http://www.worldscinet.com/srl/srl.shtml .
Please note that corrections may take a couple of weeks to filter through
the various RePEc services.