IDEAS home Printed from https://ideas.repec.org/a/spr/eurphb/v20y2001i1d10.1007_s100510170291.html
   My bibliography  Save this article

High quality CVD diamond: a Raman scattering and photoluminescence study

Author

Listed:
  • M.G. Donato

    (INFM, Dipartimento di Meccanica e Materiali, Facoltà di Ingegneria dell'Università, Località Feo di Vito, 89060 Reggio Calabria, Italy)

  • G. Faggio

    (INFM, Dipartimento di Meccanica e Materiali, Facoltà di Ingegneria dell'Università, Località Feo di Vito, 89060 Reggio Calabria, Italy)

  • M. Marinelli

    (INFM, Dipartimento di Scienze e Tecnologie Fisiche ed Energetiche, Università di Roma Tor Vergata, via di Tor Vergata, 00133 Roma, Italy)

  • G. Messina

    (INFM, Dipartimento di Meccanica e Materiali, Facoltà di Ingegneria dell'Università, Località Feo di Vito, 89060 Reggio Calabria, Italy)

  • E. Milani

    (INFM, Dipartimento di Scienze e Tecnologie Fisiche ed Energetiche, Università di Roma Tor Vergata, via di Tor Vergata, 00133 Roma, Italy)

  • A. Paoletti

    (INFM, Dipartimento di Scienze e Tecnologie Fisiche ed Energetiche, Università di Roma Tor Vergata, via di Tor Vergata, 00133 Roma, Italy)

  • S. Santangelo

    (INFM, Dipartimento di Meccanica e Materiali, Facoltà di Ingegneria dell'Università, Località Feo di Vito, 89060 Reggio Calabria, Italy)

  • A. Tucciarone

    (INFM, Dipartimento di Scienze e Tecnologie Fisiche ed Energetiche, Università di Roma Tor Vergata, via di Tor Vergata, 00133 Roma, Italy)

  • G. Verona Rinati

    (INFM, Dipartimento di Scienze e Tecnologie Fisiche ed Energetiche, Università di Roma Tor Vergata, via di Tor Vergata, 00133 Roma, Italy)

Abstract

High quality synthetic diamonds were grown on single-crystal silicon by microwave plasma enhanced chemical vapour deposition (CVD). A careful optimisation of both the experimental setup and the growth parameters was necessary before that the achievement of the best results was made possible. The films were deposited using a CH4-H2 gas mixture at methane concentrations variable in the range 0.6-2.2%, while the substrate temperature was fixed at 750 °C. Raman spectroscopy and photoluminescence (PL) were utilised to monitor the quality of the deposited films and to study the spatial distribution of defects, respectively. Micro-Raman analysis shows that linewidths of the diamond peak lower than 2.4 cm-1 can be easily measured at the growth surface, indicating that the crystalline quality of individual grains is comparable to that of the best natural diamonds. The excellent phase purity of the diamond microcrystals at the growth surface is witnessed by the complete absence of any non-diamond carbon feature and by a very weak luminescence background in the 1.6-2.4 eV spectral range. A worsening of the quality of the diamond particles is found moving from the growth surface towards the film-substrate interface. A photoluminescence feature at about 1.68 eV, commonly associated to Si impurities, is distinctly observed as the exciting laser beam is focused close to the interface. A progressive degradation of the global quality of the films is found with increasing methane concentration in the gas mixture, as witnessed by an increased PL background in the films grown at higher methane concentrations.

Suggested Citation

  • M.G. Donato & G. Faggio & M. Marinelli & G. Messina & E. Milani & A. Paoletti & S. Santangelo & A. Tucciarone & G. Verona Rinati, 2001. "High quality CVD diamond: a Raman scattering and photoluminescence study," The European Physical Journal B: Condensed Matter and Complex Systems, Springer;EDP Sciences, vol. 20(1), pages 133-139, March.
  • Handle: RePEc:spr:eurphb:v:20:y:2001:i:1:d:10.1007_s100510170291
    DOI: 10.1007/s100510170291
    as

    Download full text from publisher

    File URL: http://link.springer.com/10.1007/s100510170291
    File Function: Abstract
    Download Restriction: Access to the full text of the articles in this series is restricted.

    File URL: https://libkey.io/10.1007/s100510170291?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:spr:eurphb:v:20:y:2001:i:1:d:10.1007_s100510170291. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Sonal Shukla or Springer Nature Abstracting and Indexing (email available below). General contact details of provider: http://www.springer.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.