IDEAS home Printed from https://ideas.repec.org/a/igg/jkss00/v12y2021i4p41-70.html
   My bibliography  Save this article

Wire-EDMing Parameters Investigation and Machining Cost Analysis

Author

Listed:
  • Suchada Rianmora

    (Sirindhorn International Institute of Technology, Thammasat University, Thailand)

  • Makbul Hajad

    (Sirindhorn International Institute of Technology, Thammasat University, Thailand)

  • Viboon Tangwarodomnukun

    (King Mongkut's University of Technology, Thonburi, Thailand)

Abstract

Cost analysis of wire-EDMing operation was investigated in this study. Servo voltage, pulse on time, pulse off time, wire feed rate, and wire tension were varied in the experiment to define the optimal conditions for supporting wire-EDMing process. Taguchi's L27 orthogonal array was applied for designing the experiment. Machining cost, material removal rate (MRR), and surface roughness were taken into consideration as the process responses. From the experiment, increasing the servo voltage, pulse off time, and wire feed rate could reduce the surface roughness, whereas an increase in pulse on time and wire tension gave poor surface quality. Increasing servo voltage and pulse on time significantly affected the kerf width; comparing to other factors, they caused insignificant changes in the kerf width. Additionally, the correlation between machining cost and machining performance was analyzed and discussed in this study.

Suggested Citation

  • Suchada Rianmora & Makbul Hajad & Viboon Tangwarodomnukun, 2021. "Wire-EDMing Parameters Investigation and Machining Cost Analysis," International Journal of Knowledge and Systems Science (IJKSS), IGI Global, vol. 12(4), pages 41-70, October.
    • Handle: RePEc:igg:jkss00:v:12:y:2021:i:4:p:41-70
    as

    Download full text from publisher

    File URL: http://services.igi-global.com/resolvedoi/resolve.aspx?doi=10.4018/IJKSS.291975
    Download Restriction: no
    ---><---

    More about this item

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:igg:jkss00:v:12:y:2021:i:4:p:41-70. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Journal Editor (email available below). General contact details of provider: https://www.igi-global.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.