Sustainable Food and Feed Flours for Formaldehyde Reduction in Resins and Particleboards

Formaldehyde emissions from urea–formaldehyde (UF)-bonded particleboards remain a significant environmental and health concern. This study evaluates the effectiveness of flours as bio-based formaldehyde scavengers in particleboard production. Food-based flours (soy, wheat, green pea) and feed flours (hemp, maize DDGS, feather meal) were incorporated into UF resin at concentrations of 0.3–2.0%. Resin characterization included pH, viscosity, gelation time, solid content, and free formaldehyde, while rheological behavior was monitored at 70 °C and 90 °C. The addition of flour decreased pH from 9.1 to 7.9 and increased viscosity from 414 to up to 1600 cP, depending on flour type and dosage. Free-formaldehyde content was reduced from 0.17% to as low as 0.08%, with the most effective reduction observed for hemp flour. At industrial scale, particleboards produced with 0.5% soy and hemp flours significantly reduced free formaldehyde, with emission values of 3.26 mg/m 2 and 3.05 mg/m 2 , corresponding to reductions of 66–70% compared to the reference (3.97 mg/m 2 ). Mechanical properties, including density (652–665 kg·m −3 ), bending strength (13.2–14.1 N·mm −2 ), and internal bond (0.42–0.45 N·mm −2 ), were maintained within acceptable limits. While feed flours such as feather meal showed strong scavenging potential, they caused significant viscosity increases (up to 1800 cP), limiting processability. These findings demonstrate that adding low levels of flour, particularly soy or hemp, is an effective, renewable, and low-cost strategy to reduce formaldehyde emissions in UF-bonded particleboards, supporting the production of safer and more sustainable wood-based composites.