Towards Sustainable Urban Mobility: An Experimental Study on Vibration and Noise of Elevated Rail Transit at Different Train Speeds

Vibration and noise generated by rail transit systems pose significant constraints on their environmental sustainability. Although extensive research has been conducted by scholars on vibration and noise in rail transit, quantitative studies specifically investigating the influence of train speed on the vibration and noise of elevated rail transit are scarce. Therefore, this study selected a typical elevated section of Wuhan Metro Line 21 and systematically performed field tests to measure the vibration and noise induced by trains passing at speeds of 20, 40, 60 and 80 km·h −1 . Based on the test results, the vibration characteristics of the rails, track slab, and bridge structure, as well as the radiation characteristics of wheel–rail noise and bridge structure-borne noise under different speeds, were investigated. The study further explored the impact of train speed variation on the vibration and noise of the elevated rail transit system. The results indicate that the vibration acceleration levels of both the outer and inner rails increase significantly with train speed. Each time the speed doubles, the vibration level rises by approximately 11.5 dB for the outer rail and 10.0 dB for the inner rail. The vibration of the track slab and bridge structure is notably lower than that of the rails. Each time the speed doubles, the vibration acceleration level at various measurement points increases by an average of about 8.5–9.0 dB. Wheel–rail noise is primarily concentrated in the frequency bands around 630 Hz and 3150 Hz. Each time the speed doubles, the trackside noise level increases by an average of approximately 7.2–7.6 dB(A). Noise measured under the bridge shows a distinct peak around 100 Hz, which aligns with the vibration frequency of the bottom slab. Due to the shielding effect of shrubs, noise in the 63–100 Hz frequency band is attenuated at measurement points above ground level. Each time the speed doubles, bridge structure-borne noise increases by about 4.5–5.0 dB(A), representing a lower growth rate compared to wheel–rail noise. The findings of this research are expected to contribute to vibration and noise reduction strategies and support the sustainable development of rail transit systems.