Macroscopic Mechanical Properties of Brittle Materials with a 3D Internal Crack Based on Particle Flow Simulations

Pre-existing cracks significantly influence the macro-mechanical properties of rock. The macro-mechanical properties and crack propagation process of brittle materials with a 3D internal crack were investigated with PFC 3D simulation in this paper. To determine the micro-parameters, the influence of micro-parameters on the macro-mechanical properties and ultimate failure mode was discussed. SJM’s parameters had little influence on the macro-mechanical properties and ultimate failure mode. Peak axial stress was changed greatly by strength parameters and friction coefficient, and the macro-elastic modulus was influenced greatly by Young’s modulus and changed slightly with other parameters. The failure mode changed gradually with all micro-parameters except Young’s modulus, which had a strong but irregular impact on it. The peak stress was 138 MPa in the simulation of the sample with a 3D internal crack, which agreed well with the experimental result (137 MPa). The crack propagation process can be divided into three stages: 17% of total crack was generated in the initial stage; 76% of the total crack was propagated when main failure surface coalesced; finally, the failure surface expanded downwards and caused the sample to be destroyed. Cracks initially appeared near the end of the lower major axis of the internal crack, which was in agreement with experimental results. The results demonstrated that PFC 3D is a reliable method to simulate the failure process of brittle materials with internal cracks.