IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v15y2023i4p2960-d1059749.html
   My bibliography  Save this article

Experimental Study on Liquefaction Characteristics of Saturated Sands Mixed with Fly Ash and Tire Crumb Rubber

Author

Listed:
  • Abdülhakim Zeybek

    (Faculty of Engineering and Architecture, Muş Alparslan University, Mus 49250, Turkey)

  • Murat Eyin

    (Institute of Science and Technology, Muş Alparslan University, Mus 49250, Turkey)

Abstract

The liquefaction of saturated sandy soils during dynamic loading can inflict excessive damage on the structures, leading to significant human and economic losses. Recycling and reusing industrial waste materials may offer a sustainable and economic solution to this problem. This study investigates the influence of two waste materials, namely, recycled fly ash and tire crumb rubber, on the liquefaction characteristics of sand. For this purpose, loose and medium-dense triaxial specimens were prepared using sand–fly ash mixtures containing 0–40% of fly ash and sand–tire crumb rubber mixtures containing 0–30% of crumb rubber. The liquefaction characteristics of the specimens were examined through a series of stress-controlled, undrained, dynamic triaxial tests. The tests were conducted at 1 Hz loading frequency and under initial effective confining stresses of 50 and 100 kPa. The experimental results showed that, at a similar relative density, the liquefaction resistance of the sand–fly ash specimens decreased as the fly ash content (FA) increased up to about 20%; then, it slightly increased until FA reached 40%. Sand-only specimens showed greater liquefaction resistance than sand–fly ash specimens. The liquefaction resistance of the sand–tire crumb rubber specimens was enhanced by increasing the rubber content (RC) in the mixtures. It was found that the increasing liquefaction resistance of sand with the addition of tire crumb rubber was more noticeable under higher confining stresses.

Suggested Citation

  • Abdülhakim Zeybek & Murat Eyin, 2023. "Experimental Study on Liquefaction Characteristics of Saturated Sands Mixed with Fly Ash and Tire Crumb Rubber," Sustainability, MDPI, vol. 15(4), pages 1-24, February.
    • Handle: RePEc:gam:jsusta:v:15:y:2023:i:4:p:2960-:d:1059749
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/15/4/2960/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/15/4/2960/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Canan Turan & Akbar A. Javadi & Raffaele Vinai & Ramiz Beig Zali, 2022. "Geotechnical Characteristics of Fine-Grained Soils Stabilized with Fly Ash, a Review," Sustainability, MDPI, vol. 14(24), pages 1-31, December.
    2. Ali Tasalloti & Gabriele Chiaro & Arjun Murali & Laura Banasiak, 2021. "Physical and Mechanical Properties of Granulated Rubber Mixed with Granular Soils—A Literature Review," Sustainability, MDPI, vol. 13(8), pages 1-27, April.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Xiaolei Wang & Hai Ren & Run Liu & Libo Liu & Lin Dong & Yuchen Jiang & Zengpei Liu & Keke Li, 2023. "Study on Inhibition Range of Liquefaction of Saturated Sand by Load Using a Shaking Table Test," Sustainability, MDPI, vol. 15(9), pages 1-13, April.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Victoria Sanz Buades & Ernesto Juliá Sanchis & Jorge Segura Alcaraz & Isaac Montava Belda & José María Gadea Borrell, 2022. "Multilayer Granular Recycled Rubber for Its Application to Technical Flooring," Sustainability, MDPI, vol. 14(24), pages 1-14, December.
    2. Quadri Olakunle Babatunde & Yong-Hoon Byun, 2023. "Soil Stabilization Using Zein Biopolymer," Sustainability, MDPI, vol. 15(3), pages 1-12, January.
    3. Özgür Yıldız & Ali Firat Cabalar, 2022. "Cyclic Direct Shear Testing of a Sand with Waste Tires," Sustainability, MDPI, vol. 14(24), pages 1-25, December.
    4. Sirichai Pattanawanidchai & Pongdhorn Sae-Oui & Thipjak Na-Lumpang & Surapich Loykulnant & Thirapong Kuankhamnuan, 2023. "Reduction in Soil Compaction by Utilization of Waste Tire Rubber," Sustainability, MDPI, vol. 15(16), pages 1-13, August.
    5. Rubens Alves & Sara Rios & Eduardo Fortunato & António Viana da Fonseca & Bruno Guimarães Delgado, 2023. "Mechanical Behaviour of Steel Slag–Rubber Mixtures: Laboratory Assessment," Sustainability, MDPI, vol. 15(2), pages 1-20, January.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:15:y:2023:i:4:p:2960-:d:1059749. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.