IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i24p9459-d1002564.html
   My bibliography  Save this article

Power Generation and Microbial Community Shift According to Applied Anodic Potential in Electroactive Biofilm Reactors Treating Synthetic and Domestic Wastewater

Author

Listed:
  • Jaecheul Yu

    (Institute for Environment and Energy, Pusan National University, Busan 46241, Republic of Korea
    Department of Civil and Environmental Engineering, Pusan National University, Busan 46241, Republic of Korea)

  • Hana Park

    (Busan Health and Environmental Research Center, Busan 46616, Republic of Korea)

  • Younghyun Park

    (Environmental Technology Team, Key Industry Research Institute, Korea Testing & Research Institute, Ulsan 44412, Republic of Korea)

  • Taeho Lee

    (Institute for Environment and Energy, Pusan National University, Busan 46241, Republic of Korea
    Department of Civil and Environmental Engineering, Pusan National University, Busan 46241, Republic of Korea)

Abstract

This study investigated the effect of initially set anodic potentials (−0.3, −0.2, −0.1 and +0.1 V) on voltage production and microbial community in electroactive biofilm reactors (EBRs) treating synthetic and domestic wastewater (WW). In phase 1, EBRs were acclimated with different anodic potentials for synthetic and domestic WW. EBR (SE4) poised with +0.1 V showed the highest maximum power density (420 mW/m 2 ) for synthetic WW, while EBR (DE3) poised with −0.1 V showed the highest maximum power density (235 mW/m 2 ) for domestic WW. In phase 2, the EBRs were operated with a fixed external resistance (100 Ω for synthetic WW and 500 Ω for domestic WW) after the applied potentials were stopped. The EBRs showed slightly different voltage productions depending on the WW type and the initial anodic potential, but both EBRs applied with +0.1 V for synthetic (SE4) and domestic (DE4) WW showed the highest voltage production. Principal component analysis results based on denaturing gel gradient electrophoresis band profiles showed that the microbial community was completely different depending on the WW type. Nevertheless, it was found that the microbial community of EBRs applied with a negative potential (−0.3, −0.2, and −0.1 V) seemed to shift to those of EBRs applied with a positive potential (+0.1 V) regardless of WW type. Therefore, positive anodic potential is an important operating factor in electroactive biofilm development and voltage generation for rapid start-up.

Suggested Citation

  • Jaecheul Yu & Hana Park & Younghyun Park & Taeho Lee, 2022. "Power Generation and Microbial Community Shift According to Applied Anodic Potential in Electroactive Biofilm Reactors Treating Synthetic and Domestic Wastewater," Energies, MDPI, vol. 15(24), pages 1-12, December.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:24:p:9459-:d:1002564
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/24/9459/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/24/9459/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Pandey, Prashant & Shinde, Vikas N. & Deopurkar, Rajendra L. & Kale, Sharad P. & Patil, Sunil A. & Pant, Deepak, 2016. "Recent advances in the use of different substrates in microbial fuel cells toward wastewater treatment and simultaneous energy recovery," Applied Energy, Elsevier, vol. 168(C), pages 706-723.
    2. Lay, Chyi-How & Kokko, Marika E. & Puhakka, Jaakko A., 2015. "Power generation in fed-batch and continuous up-flow microbial fuel cell from synthetic wastewater," Energy, Elsevier, vol. 91(C), pages 235-241.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Tang, Raymond Chong Ong & Jang, Jer-Huan & Lan, Tzu-Hsuan & Wu, Jung-Chen & Yan, Wei-Mon & Sangeetha, Thangavel & Wang, Chin-Tsan & Ong, Hwai Chyuan & Ong, Zhi Chao, 2020. "Review on design factors of microbial fuel cells using Buckingham's Pi Theorem," Renewable and Sustainable Energy Reviews, Elsevier, vol. 130(C).
    2. Rousseau, Raphaël & Etcheverry, Luc & Roubaud, Emma & Basséguy, Régine & Délia, Marie-Line & Bergel, Alain, 2020. "Microbial electrolysis cell (MEC): Strengths, weaknesses and research needs from electrochemical engineering standpoint," Applied Energy, Elsevier, vol. 257(C).
    3. Hu, Jianjun & Zhang, Quanguo & Lee, Duu-Jong & Ngo, Huu Hao, 2018. "Feasible use of microbial fuel cells for pollution treatment," Renewable Energy, Elsevier, vol. 129(PB), pages 824-829.
    4. Anusha Ganta & Yasser Bashir & Sovik Das, 2022. "Dairy Wastewater as a Potential Feedstock for Valuable Production with Concurrent Wastewater Treatment through Microbial Electrochemical Technologies," Energies, MDPI, vol. 15(23), pages 1-34, November.
    5. N. Evelin Paucar & Chikashi Sato, 2022. "Coupling Microbial Fuel Cell and Hydroponic System for Electricity Generation, Organic Removal, and Nutrient Recovery via Plant Production from Wastewater," Energies, MDPI, vol. 15(23), pages 1-19, December.
    6. Xu, Lei & Wang, Bodi & Liu, Xiuhua & Yu, Wenzheng & Zhao, Yaqian, 2018. "Maximizing the energy harvest from a microbial fuel cell embedded in a constructed wetland," Applied Energy, Elsevier, vol. 214(C), pages 83-91.
    7. Shahid, Kanwal & Ramasamy, Deepika Lakshmi & Haapasaari, Sampo & Sillanpää, Mika & Pihlajamäki, Arto, 2021. "Stainless steel and carbon brushes as high-performance anodes for energy production and nutrient recovery using the microbial nutrient recovery system," Energy, Elsevier, vol. 233(C).
    8. Hani Alshahrani & Noman Islam & Darakhshan Syed & Adel Sulaiman & Mana Saleh Al Reshan & Khairan Rajab & Asadullah Shaikh & Jaweed Shuja-Uddin & Aadar Soomro, 2023. "Sustainability in Blockchain: A Systematic Literature Review on Scalability and Power Consumption Issues," Energies, MDPI, vol. 16(3), pages 1-24, February.
    9. Ortiz-Martínez, V.M. & Salar-García, M.J. & Touati, K. & Hernández-Fernández, F.J. & de los Ríos, A.P. & Belhoucine, F. & Berrabbah, A. Alioua, 2016. "Assessment of spinel-type mixed valence Cu/Co and Ni/Co-based oxides for power production in single-chamber microbial fuel cells," Energy, Elsevier, vol. 113(C), pages 1241-1249.
    10. Hassan, Sedky H.A. & el Nasser A. Zohri, Abd & Kassim, Rehab M.F., 2019. "Electricity generation from sugarcane molasses using microbial fuel cell technologies," Energy, Elsevier, vol. 178(C), pages 538-543.
    11. Liu, Huan & Yi, Linlin & Zhang, Qiang & Hu, Hongyun & Lu, Geng & Li, Aijun & Yao, Hong, 2016. "Co-production of clean syngas and ash adsorbent during sewage sludge gasification: Synergistic effect of Fenton peroxidation and CaO conditioning," Applied Energy, Elsevier, vol. 179(C), pages 1062-1068.
    12. Wang, Yuyang & Chen, Ye & Wen, Qing & Zheng, Hongtao & Xu, Haitao & Qi, Lijuan, 2019. "Electricity generation, energy storage, and microbial-community analysis in microbial fuel cells with multilayer capacitive anodes," Energy, Elsevier, vol. 189(C).
    13. Liu, Panpan & Liang, Peng & Jiang, Yong & Hao, Wen & Miao, Bo & Wang, Donglin & Huang, Xia, 2018. "Stimulated electron transfer inside electroactive biofilm by magnetite for increased performance microbial fuel cell," Applied Energy, Elsevier, vol. 216(C), pages 382-388.
    14. Ngoc-Dan Cao, Thanh & Mukhtar, Hussnain & Yu, Chang-Ping & Bui, Xuan-Thanh & Pan, Shu-Yuan, 2022. "Agricultural waste-derived biochar in microbial fuel cells towards a carbon-negative circular economy," Renewable and Sustainable Energy Reviews, Elsevier, vol. 170(C).
    15. Fischer, Fabian & Sugnaux, Marc & Savy, Cyrille & Hugenin, Gérald, 2018. "Microbial fuel cell stack power to lithium battery stack: Pilot concept for scale up," Applied Energy, Elsevier, vol. 230(C), pages 1633-1644.
    16. de Ramón-Fernández, Alberto & Salar-García, M.J. & Ruiz-Fernández, Daniel & Greenman, J. & Ieropoulos, I., 2019. "Modelling the energy harvesting from ceramic-based microbial fuel cells by using a fuzzy logic approach," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    17. Park, Jae-Do & Roane, Timberley M. & Ren, Zhiyong Jason & Alaraj, Muhannad, 2017. "Dynamic modeling of a microbial fuel cell considering anodic electron flow and electrical charge storage," Applied Energy, Elsevier, vol. 193(C), pages 507-514.
    18. Calise, Francesco & Figaj, Rafal Damian & Massarotti, Nicola & Mauro, Alessandro & Vanoli, Laura, 2017. "Polygeneration system based on PEMFC, CPVT and electrolyzer: Dynamic simulation and energetic and economic analysis," Applied Energy, Elsevier, vol. 192(C), pages 530-542.
    19. Wang, Chin-Tsan & Lee, Yao-Cheng & Ou, Yun-Ting & Yang, Yung-Chin & Chong, Wen-Tong & Sangeetha, Thangavel & Yan, Wei-Mon, 2017. "Exposing effect of comb-type cathode electrode on the performance of sediment microbial fuel cells," Applied Energy, Elsevier, vol. 204(C), pages 620-625.
    20. Wang, Zhongli & Zhang, Baogang & Jiang, Yufeng & Li, Yunlong & He, Chao, 2018. "Spontaneous thallium (I) oxidation with electricity generation in single-chamber microbial fuel cells," Applied Energy, Elsevier, vol. 209(C), pages 33-42.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:24:p:9459-:d:1002564. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.