IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v11y2018i3p541-d134481.html
   My bibliography  Save this article

Mechanical Frequency Response Analysis of Lithium-Ion Batteries to Disclose Operational Parameters

Author

Listed:
  • Hartmut Popp

    (Center for Low-Emission Transport, AIT Austrian Institute of Technology, 1210 Vienna, Austria
    Institute of Electronic Sensor Systems, Graz University of Technology, 8010 Graz, Austria)

  • Gregor Glanz

    (Center for Low-Emission Transport, AIT Austrian Institute of Technology, 1210 Vienna, Austria)

  • Karoline Alten

    (Center for Mobility Systems, AIT Austrian Institute of Technology, 1210 Vienna, Austria)

  • Irina Gocheva

    (Center for Low-Emission Transport, AIT Austrian Institute of Technology, 1210 Vienna, Austria)

  • Wernfried Berghold

    (Center for Low-Emission Transport, AIT Austrian Institute of Technology, 1210 Vienna, Austria)

  • Alexander Bergmann

    (Institute of Electronic Sensor Systems, Graz University of Technology, 8010 Graz, Austria)

Abstract

During the charge and discharge process, lithium-ion batteries change their mechanical properties due to internal structural changes caused by intercalation and de-intercalation of the ions in the anode and cathode. Furthermore, the behavior changes over the lifetime of the battery due to several degradation mechanisms. The mechanical properties of the cell hold valuable information for monitoring these changes and additionally provide data for mechanical construction and further optimization of battery systems. Hence, in this manuscript, the mechanical frequency response function is investigated as a non-destructive method to determine parameters such as stiffness and damping of pouch cells and their correlation with the state of charge (SOC), the state of health (SOH), and the temperature of the cell. Using a mechanical shaker and an impedance head, it is shown that low amplitude forces of only a few Newton and a low frequency region of several hundred Hertz already suffice to show differences in the state of charge and state of health as well as in mechanical properties and the dependencies on temperature. Also the limitations of the method are shown, as the frequency response is not distinct for each parameter and thus, at the moment, does not allow absolute determination of a single value without prior system knowledge.

Suggested Citation

  • Hartmut Popp & Gregor Glanz & Karoline Alten & Irina Gocheva & Wernfried Berghold & Alexander Bergmann, 2018. "Mechanical Frequency Response Analysis of Lithium-Ion Batteries to Disclose Operational Parameters," Energies, MDPI, vol. 11(3), pages 1-13, March.
  • Handle: RePEc:gam:jeners:v:11:y:2018:i:3:p:541-:d:134481
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/11/3/541/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/11/3/541/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Limhi Somerville & James Michael Hooper & James Marco & Andrew McGordon & Chris Lyness & Marc Walker & Paul Jennings, 2017. "Impact of Vibration on the Surface Film of Lithium-Ion Cells," Energies, MDPI, vol. 10(6), pages 1-12, May.
    2. James Michael Hooper & James Marco & Gael Henri Chouchelamane & Christopher Lyness, 2016. "Vibration Durability Testing of Nickel Manganese Cobalt Oxide (NMC) Lithium-Ion 18,650 Battery Cells," Energies, MDPI, vol. 9(1), pages 1-27, January.
    3. Panchal, S. & Dincer, I. & Agelin-Chaab, M. & Fraser, R. & Fowler, M., 2016. "Experimental and simulated temperature variations in a LiFePO4-20Ah battery during discharge process," Applied Energy, Elsevier, vol. 180(C), pages 504-515.
    4. James Michael Hooper & James Marco & Gael Henri Chouchelamane & Christopher Lyness & James Taylor, 2016. "Vibration Durability Testing of Nickel Cobalt Aluminum Oxide (NCA) Lithium-Ion 18650 Battery Cells," Energies, MDPI, vol. 9(4), pages 1-18, April.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Richard Beaumont & Iain Masters & Abhishek Das & Steve Lucas & Arunn Thanikachalam & David Williams, 2021. "Methodology for Developing a Macro Finite Element Model of Lithium-Ion Pouch Cells for Predicting Mechanical Behaviour under Multiple Loading Conditions," Energies, MDPI, vol. 14(7), pages 1-21, March.
    2. Bizhong Xia & Fan Liu & Chao Xu & Yifan Liu & Yongzhi Lai & Weiwei Zheng & Wei Wang, 2020. "Experimental and Simulation Modal Analysis of a Prismatic Battery Module," Energies, MDPI, vol. 13(8), pages 1-16, April.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Maria Cortada-Torbellino & Abdelali El Aroudi & Hugo Valderrama-Blavi, 2023. "Outlook of Lithium-Ion Battery Regulations and Procedures to Improve Cell Degradation Detection and Other Alternatives," Energies, MDPI, vol. 16(5), pages 1-13, March.
    2. Zhenhai Gao & Xiaoting Zhang & Yang Xiao & Hao Gao & Huiyuan Wang & Changhao Piao, 2019. "Influence of Low-Temperature Charge on the Mechanical Integrity Behavior of 18650 Lithium-Ion Battery Cells Subject to Lateral Compression," Energies, MDPI, vol. 12(5), pages 1-17, February.
    3. Limhi Somerville & James Michael Hooper & James Marco & Andrew McGordon & Chris Lyness & Marc Walker & Paul Jennings, 2017. "Impact of Vibration on the Surface Film of Lithium-Ion Cells," Energies, MDPI, vol. 10(6), pages 1-12, May.
    4. Lijun Zhang & Zhongqiang Mu & Xiangyu Gao, 2018. "Coupling Analysis and Performance Study of Commercial 18650 Lithium-Ion Batteries under Conditions of Temperature and Vibration," Energies, MDPI, vol. 11(10), pages 1-27, October.
    5. Sandra Castano-Solis & Daniel Serrano-Jimenez & Lucia Gauchia & Javier Sanz, 2017. "The Influence of BMSs on the Characterization and Modeling of Series and Parallel Li-Ion Packs," Energies, MDPI, vol. 10(3), pages 1-13, February.
    6. James Michael Hooper & James Marco & Gael Henri Chouchelamane & Christopher Lyness & James Taylor, 2016. "Vibration Durability Testing of Nickel Cobalt Aluminum Oxide (NCA) Lithium-Ion 18650 Battery Cells," Energies, MDPI, vol. 9(4), pages 1-18, April.
    7. Jianxun Zhang & Xiao He & Xiaosheng Si & Changhua Hu & Donghua Zhou, 2017. "A Novel Multi-Phase Stochastic Model for Lithium-Ion Batteries’ Degradation with Regeneration Phenomena," Energies, MDPI, vol. 10(11), pages 1-24, October.
    8. Ivana Semanjski & Sidharta Gautama, 2016. "Forecasting the State of Health of Electric Vehicle Batteries to Evaluate the Viability of Car Sharing Practices," Energies, MDPI, vol. 9(12), pages 1-17, December.
    9. Timur Yunusov & Maximilian J. Zangs & William Holderbaum, 2017. "Control of Energy Storage," Energies, MDPI, vol. 10(7), pages 1-5, July.
    10. Yashraj Tripathy & Andrew McGordon & Chee Tong John Low, 2018. "A New Consideration for Validating Battery Performance at Low Ambient Temperatures," Energies, MDPI, vol. 11(9), pages 1-16, September.
    11. Gandoman, Foad H. & Jaguemont, Joris & Goutam, Shovon & Gopalakrishnan, Rahul & Firouz, Yousef & Kalogiannis, Theodoros & Omar, Noshin & Van Mierlo, Joeri, 2019. "Concept of reliability and safety assessment of lithium-ion batteries in electric vehicles: Basics, progress, and challenges," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    12. Landini, S. & O’Donovan, T.S., 2021. "Novel experimental approach for the characterisation of Lithium-Ion cells performance in isothermal conditions," Energy, Elsevier, vol. 214(C).
    13. Raijmakers, L.H.J. & Danilov, D.L. & Eichel, R.-A. & Notten, P.H.L., 2019. "A review on various temperature-indication methods for Li-ion batteries," Applied Energy, Elsevier, vol. 240(C), pages 918-945.
    14. Gianluca Brando & Adolfo Dannier & Ivan Spina & Pietro Tricoli, 2017. "Integrated BMS-MMC Balancing Technique Highlighted by a Novel Space-Vector Based Approach for BEVs Application," Energies, MDPI, vol. 10(10), pages 1-14, October.
    15. Jan Kleiner & Lidiya Komsiyska & Gordon Elger & Christian Endisch, 2019. "Thermal Modelling of a Prismatic Lithium-Ion Cell in a Battery Electric Vehicle Environment: Influences of the Experimental Validation Setup," Energies, MDPI, vol. 13(1), pages 1-18, December.
    16. Yunfeng Jiang & Xin Zhao & Amir Valibeygi & Raymond A. De Callafon, 2016. "Dynamic Prediction of Power Storage and Delivery by Data-Based Fractional Differential Models of a Lithium Iron Phosphate Battery," Energies, MDPI, vol. 9(8), pages 1-17, July.
    17. Thomas Bruen & James Michael Hooper & James Marco & Miguel Gama & Gael Henri Chouchelamane, 2016. "Analysis of a Battery Management System (BMS) Control Strategy for Vibration Aged Nickel Manganese Cobalt Oxide (NMC) Lithium-Ion 18650 Battery Cells," Energies, MDPI, vol. 9(4), pages 1-20, April.
    18. Xiangyu Cui & Zhu Jing & Maji Luo & Yazhou Guo & Huimin Qiao, 2018. "A New Method for State of Charge Estimation of Lithium-Ion Batteries Using Square Root Cubature Kalman Filter," Energies, MDPI, vol. 11(1), pages 1-21, January.
    19. Pastor-Fernández, Carlos & Yu, Tung Fai & Widanage, W. Dhammika & Marco, James, 2019. "Critical review of non-invasive diagnosis techniques for quantification of degradation modes in lithium-ion batteries," Renewable and Sustainable Energy Reviews, Elsevier, vol. 109(C), pages 138-159.
    20. Vepsäläinen, Jari & Otto, Kevin & Lajunen, Antti & Tammi, Kari, 2019. "Computationally efficient model for energy demand prediction of electric city bus in varying operating conditions," Energy, Elsevier, vol. 169(C), pages 433-443.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:11:y:2018:i:3:p:541-:d:134481. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.