IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v250y2022ics0360544222006715.html
   My bibliography  Save this article

Experimental steady-state and transient thermal performance of materials for thermal energy storage in building applications: From powder SS-PCMs to SS-PCM-based acrylic plaster

Author

Listed:
  • Cárdenas-Ramírez, Carolina
  • Gómez, Maryory A.
  • Jaramillo, Franklin
  • Cardona, Andrés F.
  • Fernández, Angel G.
  • Cabeza, Luisa F.

Abstract

Thermal performance of SS-PCM composites, simulating building envelope conditions, is difficult to asset with traditional laboratory equipment. However, in this work, the evaluation of three SS-PCM based on eutectic fatty acid mixtures of capric-myristic (CA/MA), lauric-myristic (LA/MA) and palmitic-stearic (PA/SA) was accomplished by a testing setup that allows to test samples in steady-state and dynamic conditions. Moreover, a SS-PCM-based acrylic plaster was evaluated as a fiber cement siding finish. The obtained values were used to calculate the thermal transmittance (U-value), heat storage capacity, and thermal inertia parameters under a simulated diurnal cycle. Results showed that the use of phase change materials in powder form increase thermal lag between 148% and 180% and present a decrement factor <0.2. Furthermore, building envelopes as fiber cement siding with a SS-PCM-based acrylic plaster coating decreased 20.8% the indoor temperature, increase 67.26% the thermal lag and decrease 9% of the decrement factor.

Suggested Citation

  • Cárdenas-Ramírez, Carolina & Gómez, Maryory A. & Jaramillo, Franklin & Cardona, Andrés F. & Fernández, Angel G. & Cabeza, Luisa F., 2022. "Experimental steady-state and transient thermal performance of materials for thermal energy storage in building applications: From powder SS-PCMs to SS-PCM-based acrylic plaster," Energy, Elsevier, vol. 250(C).
    • Handle: RePEc:eee:energy:v:250:y:2022:i:c:s0360544222006715
    DOI: 10.1016/j.energy.2022.123768
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544222006715
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2022.123768?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. D'Alessandro, Antonella & Pisello, Anna Laura & Fabiani, Claudia & Ubertini, Filippo & Cabeza, Luisa F. & Cotana, Franco, 2018. "Multifunctional smart concretes with novel phase change materials: Mechanical and thermo-energy investigation," Applied Energy, Elsevier, vol. 212(C), pages 1448-1461.
    2. Mazzeo, Domenico & Oliveti, Giuseppe & de Gracia, Alvaro & Coma, Julià & Solé, Aran & Cabeza, Luisa F., 2017. "Experimental validation of the exact analytical solution to the steady periodic heat transfer problem in a PCM layer," Energy, Elsevier, vol. 140(P1), pages 1131-1147.
    3. Barreneche, Camila & de Gracia, Alvaro & Serrano, Susana & Elena Navarro, M. & Borreguero, Ana María & Inés Fernández, A. & Carmona, Manuel & Rodriguez, Juan Francisco & Cabeza, Luisa F., 2013. "Comparison of three different devices available in Spain to test thermal properties of building materials including phase change materials," Applied Energy, Elsevier, vol. 109(C), pages 421-427.
    4. Zhou, Dan & Eames, Philip, 2019. "Phase Change Material Wallboard (PCMW) melting temperature optimisation for passive indoor temperature control," Renewable Energy, Elsevier, vol. 139(C), pages 507-514.
    5. Pullen, James & Saeed, Khizer, 2012. "An overview of biodiesel oxidation stability," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(8), pages 5924-5950.
    6. Rasooli, Arash & Itard, Laure, 2019. "In-situ rapid determination of walls’ thermal conductivity, volumetric heat capacity, and thermal resistance, using response factors," Applied Energy, Elsevier, vol. 253(C), pages 1-1.
    7. Korkas, Christos D. & Baldi, Simone & Michailidis, Iakovos & Kosmatopoulos, Elias B., 2016. "Occupancy-based demand response and thermal comfort optimization in microgrids with renewable energy sources and energy storage," Applied Energy, Elsevier, vol. 163(C), pages 93-104.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Tullio de Rubeis & Annamaria Ciccozzi & Letizia Giusti & Dario Ambrosini, 2022. "The 3D Printing Potential for Heat Flow Optimization: Influence of Block Geometries on Heat Transfer Processes," Sustainability, MDPI, vol. 14(23), pages 1-19, November.
    2. Zuo, Peixian & Liu, Zhong & Zhang, Hua & Dai, Dasong & Fu, Ziyan & Corker, Jorge & Fan, Mizi, 2023. "Formulation and phase change mechanism of Capric acid/Octadecanol binary composite phase change materials," Energy, Elsevier, vol. 270(C).
    3. Gao, Xiangkui & Xiao, Yimin & Gao, penghui & Zhang, Zujing & Sun, Meng, 2022. "Experimental study of the effect of high humidity on the phase change plate thermal storage under natural convection," Energy, Elsevier, vol. 256(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Wang, Mei & Liu, Peng & Liu, Lang & Geng, Mingli & Wang, Yu & Zhang, Zhefeng, 2022. "The impact of the backfill direction on the backfill cooling performance using phase change materials in mine cooling," Renewable Energy, Elsevier, vol. 201(P1), pages 1026-1037.
    2. Eissa, M.M., 2018. "First time real time incentive demand response program in smart grid with “i-Energy” management system with different resources," Applied Energy, Elsevier, vol. 212(C), pages 607-621.
    3. Bimaganbetova, Madina & Memon, Shazim Ali & Sheriyev, Almas, 2020. "Performance evaluation of phase change materials suitable for cities representing the whole tropical savanna climate region," Renewable Energy, Elsevier, vol. 148(C), pages 402-416.
    4. Song, Kwonsik & Kim, Sooyoung & Park, Moonseo & Lee, Hyun-Soo, 2017. "Energy efficiency-based course timetabling for university buildings," Energy, Elsevier, vol. 139(C), pages 394-405.
    5. Pullen, James & Saeed, Khizer, 2014. "Factors affecting biodiesel engine performance and exhaust emissions – Part I: Review," Energy, Elsevier, vol. 72(C), pages 1-16.
    6. Shifa Shaffique & Sang-Mo Kang & Ah-Yeong Kim & Muhammad Imran & Muhammad Aaqil Khan & In-Jung Lee, 2021. "Current Knowledge of Medicinal Mushrooms Related to Anti-Oxidant Properties," Sustainability, MDPI, vol. 13(14), pages 1-16, July.
    7. Felix Garcia-Torres & Ascension Zafra-Cabeza & Carlos Silva & Stephane Grieu & Tejaswinee Darure & Ana Estanqueiro, 2021. "Model Predictive Control for Microgrid Functionalities: Review and Future Challenges," Energies, MDPI, vol. 14(5), pages 1-26, February.
    8. Keon Baek & Woong Ko & Jinho Kim, 2019. "Optimal Scheduling of Distributed Energy Resources in Residential Building under the Demand Response Commitment Contract," Energies, MDPI, vol. 12(14), pages 1-19, July.
    9. Amir Faraji & Maria Rashidi & Fatemeh Rezaei & Payam Rahnamayiezekavat, 2023. "A Meta-Synthesis Review of Occupant Comfort Assessment in Buildings (2002–2022)," Sustainability, MDPI, vol. 15(5), pages 1-36, February.
    10. Randeep Singh & Sadegh Sadeghi & Bahman Shabani, 2018. "Thermal Conductivity Enhancement of Phase Change Materials for Low-Temperature Thermal Energy Storage Applications," Energies, MDPI, vol. 12(1), pages 1-20, December.
    11. Xiuqiang He & Hua Geng & Geng Yang & Xin Zou, 2018. "Coordinated Control for Large-Scale Wind Farms with LCC-HVDC Integration," Energies, MDPI, vol. 11(9), pages 1-19, August.
    12. Lu, Qing & Yu, Hao & Zhao, Kangli & Leng, Yajun & Hou, Jianchao & Xie, Pinjie, 2019. "Residential demand response considering distributed PV consumption: A model based on China's PV policy," Energy, Elsevier, vol. 172(C), pages 443-456.
    13. Ye, Hong & Long, Linshuang & Zhang, Haitao & Zou, Ruqiang, 2014. "The performance evaluation of shape-stabilized phase change materials in building applications using energy saving index," Applied Energy, Elsevier, vol. 113(C), pages 1118-1126.
    14. Zhou, Yuekuan & Zheng, Siqian, 2020. "Multi-level uncertainty optimisation on phase change materials integrated renewable systems with hybrid ventilations and active cooling," Energy, Elsevier, vol. 202(C).
    15. Rostami, Sara & Afrand, Masoud & Shahsavar, Amin & Sheikholeslami, M. & Kalbasi, Rasool & Aghakhani, Saeed & Shadloo, Mostafa Safdari & Oztop, Hakan F., 2020. "A review of melting and freezing processes of PCM/nano-PCM and their application in energy storage," Energy, Elsevier, vol. 211(C).
    16. Manzano, J.M. & Salvador, J.R. & Romaine, J.B. & Alvarado-Barrios, L., 2022. "Economic predictive control for isolated microgrids based on real world demand/renewable energy data and forecast errors," Renewable Energy, Elsevier, vol. 194(C), pages 647-658.
    17. Gomez-Herrera, Juan A. & Anjos, Miguel F., 2018. "Optimal collaborative demand-response planner for smart residential buildings," Energy, Elsevier, vol. 161(C), pages 370-380.
    18. Giaouris, Damian & Papadopoulos, Athanasios I. & Patsios, Charalampos & Walker, Sara & Ziogou, Chrysovalantou & Taylor, Phil & Voutetakis, Spyros & Papadopoulou, Simira & Seferlis, Panos, 2018. "A systems approach for management of microgrids considering multiple energy carriers, stochastic loads, forecasting and demand side response," Applied Energy, Elsevier, vol. 226(C), pages 546-559.
    19. Umeozor, Evar Chinedu & Trifkovic, Milana, 2016. "Operational scheduling of microgrids via parametric programming," Applied Energy, Elsevier, vol. 180(C), pages 672-681.
    20. Nordgård-Hansen, Ellen & Kishor, Nand & Midttømme, Kirsti & Risinggård, Vetle Kjær & Kocbach, Jan, 2022. "Case study on optimal design and operation of detached house energy system: Solar, battery, and ground source heat pump," Applied Energy, Elsevier, vol. 308(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:250:y:2022:i:c:s0360544222006715. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.