IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v90y2012i1p73-79.html
   My bibliography  Save this article

Dominant factor and mechanism of coupling phenomena in single cell of polymer electrolyte fuel cell

Author

Listed:
  • Nishimura, Akira
  • Shibuya, Kenichi
  • Morimoto, Atsushi
  • Tanaka, Shigeki
  • Hirota, Masafumi
  • Nakamura, Yoshihiro
  • Kojima, Masashi
  • Narita, Masahiko
  • Hu, Eric

Abstract

The purpose of this study is to understand the dominant factor and mechanism in coupled phenomena of heat and mass transfer and power generation in a single cell of polymer electrolyte fuel cell. Through the observation window, the in-plane temperature distribution at backside of gas channel of separator on cathode side, when it generated power, was measured by thermograph. The impact of gas supply conditions, i.e., flow rate, relative humidity of supply gas and gas channel pitch of separator on in-plane temperature distribution was investigated. The voltage to the load current, temperature, relative humidity and flow rate of supply and exhaust gas were measured. As a result, it was found the consumed gas flow rate and total voltage were almost unchanged if the gas was supplied over the stoichiometric ratio of 1.0, irrespective of relative humidity of supply gas. The range of in-plane temperature distribution was reduced with increasing excess gas supply due to the convection heat transfer by unconsumed gas flow. The power generation performance was promoted and the in-plane temperature was reduced with decreasing gas channel pitch irrespective of relative humidity of supply gas.

Suggested Citation

  • Nishimura, Akira & Shibuya, Kenichi & Morimoto, Atsushi & Tanaka, Shigeki & Hirota, Masafumi & Nakamura, Yoshihiro & Kojima, Masashi & Narita, Masahiko & Hu, Eric, 2012. "Dominant factor and mechanism of coupling phenomena in single cell of polymer electrolyte fuel cell," Applied Energy, Elsevier, vol. 90(1), pages 73-79.
    • Handle: RePEc:eee:appene:v:90:y:2012:i:1:p:73-79
    DOI: 10.1016/j.apenergy.2011.01.003
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261911000067
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2011.01.003?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Perng, Shiang-Wuu & Wu, Horng-Wen, 2011. "Non-isothermal transport phenomenon and cell performance of a cathodic PEM fuel cell with a baffle plate in a tapered channel," Applied Energy, Elsevier, vol. 88(1), pages 52-67, January.
    2. Perng, Shiang-Wuu & Wu, Horng-Wen & Jue, Tswen-Chyuan & Cheng, Kuo-Chih, 2009. "Numerical predictions of a PEM fuel cell performance enhancement by a rectangular cylinder installed transversely in the flow channel," Applied Energy, Elsevier, vol. 86(9), pages 1541-1554, September.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Akira Nishimura & Daiki Mishima & Kyohei Toyoda & Syogo Ito & Mohan Lal Kolhe, 2023. "Numerical Simulation on Effect of Separator Thickness on Coupling Phenomena in Single Cell of PEFC under Higher Temperature Operation Condition at 363 K and 373 K," Energies, MDPI, vol. 16(2), pages 1-28, January.
    2. Akira Nishimura & Kyohei Toyoda & Yuya Kojima & Syogo Ito & Eric Hu, 2021. "Numerical Simulation on Impacts of Thickness of Nafion Series Membranes and Relative Humidity on PEMFC Operated at 363 K and 373 K," Energies, MDPI, vol. 14(24), pages 1-24, December.
    3. Teresa J. Leo & Miguel A. Raso & Emilio Navarro & Eleuterio Mora, 2013. "Long Term Performance Study of a Direct Methanol Fuel Cell Fed with Alcohol Blends," Energies, MDPI, vol. 6(1), pages 1-12, January.
    4. Tang, Hong-Yue & Santamaria, Anthony D. & Bachman, John & Park, Jae Wan, 2013. "Vacuum-assisted drying of polymer electrolyte membrane fuel cell," Applied Energy, Elsevier, vol. 107(C), pages 264-270.
    5. Akira Nishimura & Nozomu Kono & Kyohei Toyoda & Daiki Mishima & Mohan Lal Kolhe, 2022. "Impact of Separator Thickness on Temperature Distribution in Single Cell of Polymer Electrolyte Fuel Cell Operated at Higher Temperature of 90 °C and 100 °C," Energies, MDPI, vol. 15(12), pages 1-25, June.
    6. Wang, H.Y. & Yang, W.J. & Kim, Y.B., 2014. "Analyzing in-plane temperature distribution via a micro-temperature sensor in a unit polymer electrolyte membrane fuel cell," Applied Energy, Elsevier, vol. 124(C), pages 148-155.
    7. Nishimura, Akira & Yamamoto, Kohei & Okado, Tatsuya & Kojima, Yuya & Hirota, Masafumi & Kolhe, Mohan Lal, 2020. "Impact analysis of MPL and PEM thickness on temperature distribution within PEFC operating at relatively higher temperature," Energy, Elsevier, vol. 205(C).
    8. Lin, Chien-Hung & Tsai, Sung-Ying, 2012. "An investigation of coated aluminium bipolar plates for PEMFC," Applied Energy, Elsevier, vol. 100(C), pages 87-92.
    9. Lin, Chien-Hung, 2013. "Surface roughness effect on the metallic bipolar plates of a proton exchange membrane fuel cell," Applied Energy, Elsevier, vol. 104(C), pages 898-904.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Wenkai & Zhang, Qinglei & Wang, Chao & Yan, Xiaohui & Shen, Shuiyun & Xia, Guofeng & Zhu, Fengjuan & Zhang, Junliang, 2017. "Experimental and numerical analysis of a three-dimensional flow field for PEMFCs," Applied Energy, Elsevier, vol. 195(C), pages 278-288.
    2. Chiu, Han-Chieh & Jang, Jer-Huan & Yan, Wei-Mon & Li, Hung-Yi & Liao, Chih-Cheng, 2012. "A three-dimensional modeling of transport phenomena of proton exchange membrane fuel cells with various flow fields," Applied Energy, Elsevier, vol. 96(C), pages 359-370.
    3. Ismail, M.S. & Hughes, K.J. & Ingham, D.B. & Ma, L. & Pourkashanian, M., 2012. "Effects of anisotropic permeability and electrical conductivity of gas diffusion layers on the performance of proton exchange membrane fuel cells," Applied Energy, Elsevier, vol. 95(C), pages 50-63.
    4. Perng, Shiang-Wuu & Horng, Rong-Fang & Ku, Hui-Wen, 2013. "Effects of reaction chamber geometry on the performance and heat/mass transport phenomenon for a cylindrical methanol steam reformer," Applied Energy, Elsevier, vol. 103(C), pages 317-327.
    5. Ko, Johan & Ju, Hyunchul, 2012. "Comparison of numerical simulation results and experimental data during cold-start of polymer electrolyte fuel cells," Applied Energy, Elsevier, vol. 94(C), pages 364-374.
    6. Hwang, Jenn-Jiang, 2013. "Thermal control and performance assessment of a proton exchanger membrane fuel cell generator," Applied Energy, Elsevier, vol. 108(C), pages 184-193.
    7. Yan, Wei-Mon & Wang, Xiao-Dong & Lee, Duu-Jong & Zhang, Xin-Xin & Guo, Yi-Fan & Su, Ay, 2011. "Experimental study of commercial size proton exchange membrane fuel cell performance," Applied Energy, Elsevier, vol. 88(1), pages 392-396, January.
    8. Liu, Lina & Guo, Lingyi & Zhang, Ruiyuan & Chen, Li & Tao, Wen-Quan, 2021. "Numerically investigating two-phase reactive transport in multiple gas channels of proton exchange membrane fuel cells," Applied Energy, Elsevier, vol. 302(C).
    9. Cao, Tao-Feng & Lin, Hong & Chen, Li & He, Ya-Ling & Tao, Wen-Quan, 2013. "Numerical investigation of the coupled water and thermal management in PEM fuel cell," Applied Energy, Elsevier, vol. 112(C), pages 1115-1125.
    10. Perng, Shiang-Wuu & Wu, Horng-Wen, 2015. "A three-dimensional numerical investigation of trapezoid baffles effect on non-isothermal reactant transport and cell net power in a PEMFC," Applied Energy, Elsevier, vol. 143(C), pages 81-95.
    11. Dong, Pengcheng & Xie, Gongnan & Ni, Meng, 2020. "The mass transfer characteristics and energy improvement with various partially blocked flow channels in a PEM fuel cell," Energy, Elsevier, vol. 206(C).
    12. Wang, Chin-Tsan & Hu, Yuh-Chung & Zheng, Pei-Lun, 2010. "Novel biometric flow slab design for improvement of PEMFC performance," Applied Energy, Elsevier, vol. 87(4), pages 1366-1375, April.
    13. Wu, Horng-Wen & Ku, Hui-Wen, 2011. "The optimal parameters estimation for rectangular cylinders installed transversely in the flow channel of PEMFC from a three-dimensional PEMFC model and the Taguchi method," Applied Energy, Elsevier, vol. 88(12), pages 4879-4890.
    14. Alaefour, Ibrahim & Karimi, G. & Jiao, Kui & Li, X., 2012. "Measurement of current distribution in a proton exchange membrane fuel cell with various flow arrangements – A parametric study," Applied Energy, Elsevier, vol. 93(C), pages 80-89.
    15. Henriques, T. & César, B. & Branco, P.J. Costa, 2010. "Increasing the efficiency of a portable PEM fuel cell by altering the cathode channel geometry: A numerical and experimental study," Applied Energy, Elsevier, vol. 87(4), pages 1400-1409, April.
    16. Sasmito, Agus P. & Kurnia, Jundika C. & Mujumdar, Arun S., 2012. "Numerical evaluation of various gas and coolant channel designs for high performance liquid-cooled proton exchange membrane fuel cell stacks," Energy, Elsevier, vol. 44(1), pages 278-291.
    17. Wu, Horng-Wen, 2016. "A review of recent development: Transport and performance modeling of PEM fuel cells," Applied Energy, Elsevier, vol. 165(C), pages 81-106.
    18. Baricci, Andrea & Mereu, Riccardo & Messaggi, Mirko & Zago, Matteo & Inzoli, Fabio & Casalegno, Andrea, 2017. "Application of computational fluid dynamics to the analysis of geometrical features in PEM fuel cells flow fields with the aid of impedance spectroscopy," Applied Energy, Elsevier, vol. 205(C), pages 670-682.
    19. Perng, Shiang-Wuu & Horng, Rong-Fang & Wu, Horng-Wen, 2017. "Effect of a diffuser on performance enhancement of a cylindrical methanol steam reformer by computational fluid dynamic analysis," Applied Energy, Elsevier, vol. 206(C), pages 312-328.
    20. Hwang, Jenn-Jiang & Dlamini, Mangaliso Menzi & Weng, Fang-Bor & Chang, Tseng & Lin, Chih-Hong & Weng, Shih-Cheng, 2022. "Simulation of fine mesh implementation on the cathode for proton exchange membrane fuel cell (PEMFC)," Energy, Elsevier, vol. 244(PA).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:90:y:2012:i:1:p:73-79. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.