IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i19p6296-d648915.html
   My bibliography  Save this article

Effects of Positioning of Multi-Sensor Devices on Occupancy and Indoor Environmental Monitoring in Single-Occupant Offices

Author

Listed:
  • Shoaib Azizi

    (Department of Applied Physics and Electronics, Umeå University, 901 87 Umeå, Sweden)

  • Ramtin Rabiee

    (Department of Applied Physics and Electronics, Umeå University, 901 87 Umeå, Sweden)

  • Gireesh Nair

    (Department of Applied Physics and Electronics, Umeå University, 901 87 Umeå, Sweden)

  • Thomas Olofsson

    (Department of Applied Physics and Electronics, Umeå University, 901 87 Umeå, Sweden)

Abstract

The advancements in sensor and communication technologies drive the rapid developments in the applications of occupancy and indoor environmental monitoring in buildings. Currently, the installation standards for sensors are scarce and the recommendations for sensor positionings are very general. However, inadequate sensor positioning might diminish the reliability of sensor data, which could have serious impacts on the intended applications such as the performance of demand-controlled HVAC systems and their energy use. Thus, there is a need to understand how sensor positioning may affect the sensor data, specifically when using multi-sensor devices in which several sensors are being bundled together. This study is based on the data collected from 18 multi-sensor devices installed in three single-occupant offices (six sensors in each office). Each multi-sensor device included sensors to measure passive infrared (PIR) radiation, temperature, CO 2 , humidity, and illuminance. The results show that the positions of PIR and CO 2 sensors significantly affect the reliability of occupancy detection. The typical approach of positioning the sensors on the ceiling, in the middle of offices, may lead to relatively unreliable data. In this case, the PIR sensor in that position has only 60% accuracy of presence detection. Installing the sensors under office desks could increase the accuracy of presence detection to 84%. These two sensor positions are highlighted in sensor fusion analysis as they could reach the highest accuracy compared to other pairs of PIR sensors. Moreover, sensor positioning can affect various indoor environmental parameters, especially temperature and illuminance measurements.

Suggested Citation

  • Shoaib Azizi & Ramtin Rabiee & Gireesh Nair & Thomas Olofsson, 2021. "Effects of Positioning of Multi-Sensor Devices on Occupancy and Indoor Environmental Monitoring in Single-Occupant Offices," Energies, MDPI, vol. 14(19), pages 1-23, October.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:19:p:6296-:d:648915
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/19/6296/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/19/6296/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Menezes, Anna Carolina & Cripps, Andrew & Bouchlaghem, Dino & Buswell, Richard, 2012. "Predicted vs. actual energy performance of non-domestic buildings: Using post-occupancy evaluation data to reduce the performance gap," Applied Energy, Elsevier, vol. 97(C), pages 355-364.
    2. Eunil Park & Angel P. Del Pobil & Sang Jib Kwon, 2018. "The Role of Internet of Things (IoT) in Smart Cities: Technology Roadmap-oriented Approaches," Sustainability, MDPI, vol. 10(5), pages 1-13, May.
    3. Lin, Hung-Wen & Hong, Tianzhen, 2013. "On variations of space-heating energy use in office buildings," Applied Energy, Elsevier, vol. 111(C), pages 515-528.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Aya Nabil Sayed & Faycal Bensaali & Yassine Himeur & Mahdi Houchati, 2023. "Edge-Based Real-Time Occupancy Detection System through a Non-Intrusive Sensing System," Energies, MDPI, vol. 16(5), pages 1-14, March.
    2. Muhammad Emad-Ud-Din & Ya Wang, 2023. "Indoor Occupancy Sensing via Networked Nodes (2012–2022): A Review," Future Internet, MDPI, vol. 15(3), pages 1-20, March.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ghahramani, Ali & Zhang, Kenan & Dutta, Kanu & Yang, Zheng & Becerik-Gerber, Burcin, 2016. "Energy savings from temperature setpoints and deadband: Quantifying the influence of building and system properties on savings," Applied Energy, Elsevier, vol. 165(C), pages 930-942.
    2. Tian, Wei & Song, Jitian & Li, Zhanyong & de Wilde, Pieter, 2014. "Bootstrap techniques for sensitivity analysis and model selection in building thermal performance analysis," Applied Energy, Elsevier, vol. 135(C), pages 320-328.
    3. Saveria Olga Murielle Boulanger, 2022. "The Roadmap to Smart Cities: A Bibliometric Literature Review on Smart Cities’ Trends before and after the COVID-19 Pandemic," Energies, MDPI, vol. 15(24), pages 1-19, December.
    4. Jakob Carlander & Bahram Moshfegh & Jan Akander & Fredrik Karlsson, 2020. "Effects on Energy Demand in an Office Building Considering Location, Orientation, Façade Design and Internal Heat Gains—A Parametric Study," Energies, MDPI, vol. 13(23), pages 1-22, November.
    5. Lee, Junghun & Kim, Jeonggook & Song, Doosam & Kim, Jonghun & Jang, Cheolyong, 2017. "Impact of external insulation and internal thermal density upon energy consumption of buildings in a temperate climate with four distinct seasons," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 1081-1088.
    6. Wang, Lan & Lee, Eric W.M. & Hussian, Syed Asad & Yuen, Anthony Chun Yin & Feng, Wei, 2021. "Quantitative impact analysis of driving factors on annual residential building energy end-use combining machine learning and stochastic methods," Applied Energy, Elsevier, vol. 299(C).
    7. Glasgo, Brock & Hendrickson, Chris & Azevedo, Inês Lima, 2017. "Assessing the value of information in residential building simulation: Comparing simulated and actual building loads at the circuit level," Applied Energy, Elsevier, vol. 203(C), pages 348-363.
    8. De Boeck, L. & Verbeke, S. & Audenaert, A. & De Mesmaeker, L., 2015. "Improving the energy performance of residential buildings: A literature review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 52(C), pages 960-975.
    9. Abdulazeez Rotimi & Ali Bahadori-Jahromi & Anastasia Mylona & Paulina Godfrey & Darren Cook, 2017. "Estimation and Validation of Energy Consumption in UK Existing Hotel Building Using Dynamic Simulation Software," Sustainability, MDPI, vol. 9(8), pages 1-18, August.
    10. Ruparathna, Rajeev & Hewage, Kasun & Sadiq, Rehan, 2016. "Improving the energy efficiency of the existing building stock: A critical review of commercial and institutional buildings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 53(C), pages 1032-1045.
    11. Azar, Elie & Nikolopoulou, Christina & Papadopoulos, Sokratis, 2016. "Integrating and optimizing metrics of sustainable building performance using human-focused agent-based modeling," Applied Energy, Elsevier, vol. 183(C), pages 926-937.
    12. Zulay Giménez & Claudio Mourgues & Luis F. Alarcón & Harrison Mesa & Eugenio Pellicer, 2020. "Value Analysis Model to Support the Building Design Process," Sustainability, MDPI, vol. 12(10), pages 1-24, May.
    13. Naylor, Sophie & Gillott, Mark & Lau, Tom, 2018. "A review of occupant-centric building control strategies to reduce building energy use," Renewable and Sustainable Energy Reviews, Elsevier, vol. 96(C), pages 1-10.
    14. Zhao, Dong-Xue & He, Bao-Jie & Johnson, Christine & Mou, Ben, 2015. "Social problems of green buildings: From the humanistic needs to social acceptance," Renewable and Sustainable Energy Reviews, Elsevier, vol. 51(C), pages 1594-1609.
    15. Ljubomir Jankovic, 2016. "Reducing Simulation Performance Gap in Hemp-Lime Buildings Using Fourier Filtering †," Sustainability, MDPI, vol. 8(9), pages 1-16, August.
    16. Abdo Abdullah Ahmed Gassar & Choongwan Koo & Tae Wan Kim & Seung Hyun Cha, 2021. "Performance Optimization Studies on Heating, Cooling and Lighting Energy Systems of Buildings during the Design Stage: A Review," Sustainability, MDPI, vol. 13(17), pages 1-47, September.
    17. Pisello, Anna Laura & Asdrubali, Francesco, 2014. "Human-based energy retrofits in residential buildings: A cost-effective alternative to traditional physical strategies," Applied Energy, Elsevier, vol. 133(C), pages 224-235.
    18. Roberto Robledo-Fava & Mónica C. Hernández-Luna & Pedro Fernández-de-Córdoba & Humberto Michinel & Sonia Zaragoza & A Castillo-Guzman & Romeo Selvas-Aguilar, 2019. "Analysis of the Influence Subjective Human Parameters in the Calculation of Thermal Comfort and Energy Consumption of Buildings," Energies, MDPI, vol. 12(8), pages 1-23, April.
    19. Ahmed WA Hammad & Ali Akbarnezhad & Assed Haddad & Elaine Garrido Vazquez, 2019. "Sustainable Zoning, Land-Use Allocation and Facility Location Optimisation in Smart Cities," Energies, MDPI, vol. 12(7), pages 1-23, April.
    20. Krarti, Moncef & Dubey, Kankana & Howarth, Nicholas, 2019. "Energy productivity analysis framework for buildings: a case study of GCC region," Energy, Elsevier, vol. 167(C), pages 1251-1265.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:19:p:6296-:d:648915. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.