IDEAS home Printed from https://ideas.repec.org/a/vrs/repfms/v26y2018i42p119-126n14.html
   My bibliography  Save this article

Analysis of the Surface Morphology of the S235JRG1 Steel After an Abrasive Water Jet Cutting Process

Author

Listed:
  • Moravčíková Jana
  • Delgado Sobrino Daynier Rolando
  • Košťál Peter

    (Slovak University of Technology in Bratislava, Faculty of Materials Science and Technology in Trnava, Institute of Production Technologies, Ulica Jána Bottu 2781/25, 917 24 Trnava, Slovak Republic)

Abstract

The present paper discusses the impact of the speed of an abrasive water jet cutting process on some surface properties and morphology of the S235JRG1 steel. The values of the cutting speeds used for the analysis were of 100, 150 and 200 mm.min−1 respectively. A contact profile method was used to analyze the surface roughness during the conducted tests. In this study, the observed surface roughness parameters were the Ra, Rt and Rz, respectively. At the same time, these parameters were measured in three positions, i.e.: at the inlet (A), in the middle (B) and at the exit position (C) of the water jet nozzle with respect to the machined material. The experimental study showed that the roughness of the surface reached higher peaks and was more pronounced at the exit position (C) of the water jet. Similarly, it was also concluded that a better quality of the surface was achieved at a speed of 150 mm.min−1.

Suggested Citation

  • Moravčíková Jana & Delgado Sobrino Daynier Rolando & Košťál Peter, 2018. "Analysis of the Surface Morphology of the S235JRG1 Steel After an Abrasive Water Jet Cutting Process," Research Papers Faculty of Materials Science and Technology Slovak University of Technology, Sciendo, vol. 26(42), pages 119-126, June.
    • Handle: RePEc:vrs:repfms:v:26:y:2018:i:42:p:119-126:n:14
    DOI: 10.2478/rput-2018-0014
    as

    Download full text from publisher

    File URL: https://doi.org/10.2478/rput-2018-0014
    Download Restriction: no
    File URL: https://libkey.io/10.2478/rput-2018-0014?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:vrs:repfms:v:26:y:2018:i:42:p:119-126:n:14. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Peter Golla (email available below). General contact details of provider: https://www.sciendo.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.