IDEAS home Printed from https://ideas.repec.org/a/vrs/repfms/v21y2013ispecial_issuep193-198n32.html
   My bibliography  Save this article

Development of Surface Roughness in Hard Turning of 100Cr6 Using Mixed Ceramic Cutting Tool with Wiper Geometry and Conventional Geometry

Author

Listed:
  • Samardžiová Michaela

    (Faculty of Materials Science and Technology, Slovak University of Technology, J. Bottu 25, 917 24 Trnava, Slovak Republic)

  • Neslušan Miroslav

    (Faculty of Mechanical Engineering, University of Žilina, Univerzitná 8215/1, 010 26 Žilina, Slovak Republic)

Abstract

Hard turning has been applied in machining since the early 1980s. There is an effort to substitute finish grinding by hard machining, because of machining by cutting tool with defined geometry. For machining of hardened steels (up to 45 HRC) are used two different cutting materials. PCBN are used the most for discontinuous machining of hardened steel (up to 63 HRC) and mixed ceramic tools, which are used in the experiment. This paper reports a development of surface roughness parameters when using wiper tool geometry of mixed ceramic tool and conventional geometry of mixed ceramic tool in hard turning. Roughness parameters (Ra, Rz, Rsk, Rku, RSm, Rdq) are measured when changing the feed, depth of cut and cutting speed are constant.

Suggested Citation

  • Samardžiová Michaela & Neslušan Miroslav, 2013. "Development of Surface Roughness in Hard Turning of 100Cr6 Using Mixed Ceramic Cutting Tool with Wiper Geometry and Conventional Geometry," Research Papers Faculty of Materials Science and Technology Slovak University of Technology, Sciendo, vol. 21(Special I), pages 193-198, June.
    • Handle: RePEc:vrs:repfms:v:21:y:2013:i:special_issue:p:193-198:n:32
    DOI: 10.2478/rput-2013-0032
    as

    Download full text from publisher

    File URL: https://doi.org/10.2478/rput-2013-0032
    Download Restriction: no
    File URL: https://libkey.io/10.2478/rput-2013-0032?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    More about this item

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:vrs:repfms:v:21:y:2013:i:special_issue:p:193-198:n:32. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Peter Golla (email available below). General contact details of provider: https://www.sciendo.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.