IDEAS home Printed from https://ideas.repec.org/a/vrs/enviro/v11y2023i4p62-76n1.html
   My bibliography  Save this article

Record of aeolian processes in Pleistocene deposits in the foreland of the European sand belt

Author

Listed:
  • Dulias Renata

    (1 University of Silesia in Katowice, Faculty of Natural Sciences, Institute of Earth Sciences, 60 Będzińska Str., 41-200, Sosnowiec, Poland)

Abstract

This article presents the degree of aeolization of Pleistocene deposits in the foreground of the European sand belt in southern Poland. Ten of the 13 sites were established in the Oświęcim Basin and three in the south part of the Silesian Upland. Attention was focused on four types of deposits formed during three glaciations (Sanian, Odranian, Vistulian): boulder clay, fluvioglacial sands and gravels, end moraine deposits, and aeolian sands. Quartz grain abrasion (for the 0.8–1.0 mm fraction) was examined by mechanical graniformametry and the morphoscopic method. The record of aeolian processes in analyzed deposits is the presence of quartz grains RM (very well-rounded and mat) and EM/RM (moderately rounded and mat). They were found in deposits of various origins and ages but in variable proportions. Considering only the average percentage of grains RM, it should be regarded that abrasion of deposits is low in the case of fluvioglacial deposits, moderate in the case of glacial deposits, and good in the case of aeolian deposits. However, the key factor in determining the degree of abrasion is the share of EM/RM grains, which in the abovementioned deposits are seven, three, and twice as many as RM grains. Therefore, the most noteworthy research result is the very high total share of grains with aeolian abrasion (RM + EM/RM), amounting on average to 84.1% for Odranian fluvioglacial deposits, 86.7% for Sanian glacial deposits and 92.6% for Late Glacial aeolian deposits. It means that in the study area, glacial and fluvioglacial transport included deposits with good aeolian abrasion obtained in the periglacial environment before the transgression of the ice sheets. Probably due to the longer persistence of periglacial conditions in southern Poland, compared to its central and northern parts, the degree of aeolization of fluvioglacial and glacial deposits is better. At the same time, there is a significant differentiation in the aeolization of fluvioglacial deposits within the outwash plain in the foreland of the maximum extent of the Odranian ice sheet. In its proximal part, near the front of the ice sheet, fluvioglacial deposits are characterized by much worse abrasion of quartz grains than in the distal part.

Suggested Citation

  • Dulias Renata, 2023. "Record of aeolian processes in Pleistocene deposits in the foreland of the European sand belt," Environmental & Socio-economic Studies, Sciendo, vol. 11(4), pages 62-76, December.
  • Handle: RePEc:vrs:enviro:v:11:y:2023:i:4:p:62-76:n:1
    DOI: 10.2478/environ-2023-0024
    as

    Download full text from publisher

    File URL: https://doi.org/10.2478/environ-2023-0024
    Download Restriction: no

    File URL: https://libkey.io/10.2478/environ-2023-0024?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:vrs:enviro:v:11:y:2023:i:4:p:62-76:n:1. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Peter Golla (email available below). General contact details of provider: https://www.sciendo.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.