Low and high viscosity bulk-fill composite resins stress distribution in primary molar tooth inlay cavity

The aim of this study is to evaluate the stress distributions of low and high viscosity bulk-fill composite resins at class II MOD inlay cavity in primary molar tooth using Finite Element Analysis (FEA). Original DICOM data of a primary molar tooth from a research archive was used to create a 3D model. Two models were prepared as Model 1: the tooth model without restoration (control group) and Model 2: the tooth model with class II MOD inlay restoration. Two different bulk-fill composite resins were tested in study: Model 2 A (class II MOD inlay cavity model restored with low viscosity bulk-fill composite resin) and Model 2B (class II MOD inlay cavity model restored with high viscosity bulk-fill composite resin). Occlusal vertical loading of 232 N was applied to the teeth in occlusal contact areas. Maximum Von Mises stress values in the models for enamel, dentin, and restorative material were evaluated as MPa. More intense stress accumulation is observed in enamel than in dentin. In addition, more stress values were determined in Model 2B (206.15 MPa, 32.76 MPa, 128.95 MPa) than in Model 2 A (203.39 MPa, 29.77 MPa, 120.61 MPa) for enamel, dentin and restorative material, respectively.