IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v14y2022i8p4504-d790668.html
   My bibliography  Save this article

Evaluation of a Polyester Filter and UV Light (PFUV) Dehumidifier to Improve Indoor Environmental Quality: Preliminary Results

Author

Listed:
  • Mohammad Al-Rawi

    (Centre for Engineering and Industrial Design (CEID), Waikato Institute of Technology, Hamilton 3240, New Zealand)

  • Mohammed M. Farid

    (Department of Chemical & Materials Engineering, University of Auckland, Auckland 1010, New Zealand)

  • Rhys J. Jones

    (Centre for Applied Science and Primary Industries, Waikato Institute of Technology, Hamilton 3240, New Zealand)

  • Ken Louie

    (Centre for Engineering and Industrial Design (CEID), Waikato Institute of Technology, Hamilton 3240, New Zealand)

Abstract

Older residential dwellings in New Zealand frequently suffer from poor indoor environmental quality (IEQ) due to an ageing housing stock. Recent New Zealand surveys indicated around 50% of children live in houses that do not meet acceptable standards for thermal comfort. Children in these houses frequently experience respiratory conditions caused by dampness and mould during winter. New regulatory standards requiring a fixed heating source in the main living room of rental houses can increase rents and may result in the heating source not being utilized. This study evaluates an alternative low-cost portable air filter/sterilizer (PFUV) dehumidifier device for improving IEQ within the building envelope using Ultraviolet Germicidal Irradiation (UVGI) and a polyester filter (dual-10 30/30). This paper compares the effectiveness of the PFUV dehumidifier device and a conventional heat pump in terms of measured particulate matters as well as fungal profiles using Potato Dextrose Agar (PDA) plates. The PFUV dehumidifier successfully reduced the relative humidity to within a healthy range of (44–49%) compared to not running the device (54–60%), thereby reducing the suitability of the environment for mould growth. Additionally, the PFUV device achieved a reduction in average particulate matter (PM 2.5 ) to within the range of 0.16 to 0.53 µg/m³ compared to the range of 1.06 to 2.42 µg/m³ before using the device.

Suggested Citation

  • Mohammad Al-Rawi & Mohammed M. Farid & Rhys J. Jones & Ken Louie, 2022. "Evaluation of a Polyester Filter and UV Light (PFUV) Dehumidifier to Improve Indoor Environmental Quality: Preliminary Results," Sustainability, MDPI, vol. 14(8), pages 1-19, April.
    • Handle: RePEc:gam:jsusta:v:14:y:2022:i:8:p:4504-:d:790668
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/14/8/4504/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/14/8/4504/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Seung-Hoon Park & Jae-Hun Jo & Eui-Jong Kim, 2021. "Data-Driven Models for Estimating Dust Loading Levels of ERV HEPA Filters," Sustainability, MDPI, vol. 13(24), pages 1-14, December.
    2. Kyungjoo Cho & Chang-U Chae & Dongwoo Cho & Taeyeon Kim, 2021. "Changes in Fan Energy Consumption According to Filters Installed in Residential Heat Recovery Ventilators in Korea," Sustainability, MDPI, vol. 13(18), pages 1-12, September.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Marta Fonseca Gabriel & João Pedro Cardoso & Fátima Felgueiras & Joana Azeredo & David Filipe & Peter Conradie & Stephanie Van Hove & Zenaida Mourão & Filippos Anagnostopoulos & Isabel Azevedo, 2023. "Opportunities for Promoting Healthy Homes and Long-Lasting Energy-Efficient Behaviour among Families with Children in Portugal," Energies, MDPI, vol. 16(4), pages 1-20, February.
    2. Abhimannyu Sharma & Dheeraj Kumar & Amit Kumar & Nadeem Faisal & Naresh Kumar & Shatrudhan Pandey & S. M. Mozammil Hasnain & Tahani Mohamed Al-Hazani & Abdullah A. AlKahtane & Saad Alkahtani & Rajeshw, 2023. "Designing, Modeling, and Fabrication of a Novel Solar-Concentrating Spittoon against COVID-19 for Antibacterial Sustainable Atmosphere," Sustainability, MDPI, vol. 15(12), pages 1-17, June.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Simon Li, 2023. "Review of Engineering Controls for Indoor Air Quality: A Systems Design Perspective," Sustainability, MDPI, vol. 15(19), pages 1-46, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:14:y:2022:i:8:p:4504-:d:790668. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.