IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i6p1341-d1354972.html
   My bibliography  Save this article

Numerical Simulation on Two-Phase Ejector with Non-Condensable Gas

Author

Listed:
  • Yinghua Chai

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

  • Yuansheng Lin

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

  • Qi Xiao

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

  • Chonghai Huang

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

  • Hanbing Ke

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

  • Bangming Li

    (Science and Technology on Thermal Energy and Power Laboratory, Wuhan 430205, China
    Wuhan Second Ship Design and Research Institute, Wuhan 430205, China)

Abstract

The two-phase ejector is a simple and compact pressure boosting device and widely used in ejector steam-generator water feeding systems and core emergency cooling systems. The direct contact condensation of water and steam is the key process of a two-phase ejector. Usually, the high-temperature and high-pressure steam will inevitably induce non-condensable gases. The existence of non-condensable gases will reduce the condensation heat transfer rate between steam and water, and harm the equipment. This study carried out 3D numerical simulations of a two-phase ejector based on an inhomogeneous multiphase model. The steam inlet pressure and the non-condensable gas mass fraction rang in 0.6–2.9 MPa and 1–10%, respectively. The heat and mass transfer characteristics were analyzed under different conditions. The results show that the heat transfer coefficient and plume penetration length increased with the steam inlet pressure. Non-condensable gas prevents direct contact condensation between the steam and water. The non-condensable gas mass fraction rises from 1% to 10%, the heat transfer between steam and water deteriorates, and leads to a lower heat transfer coefficient.

Suggested Citation

  • Yinghua Chai & Yuansheng Lin & Qi Xiao & Chonghai Huang & Hanbing Ke & Bangming Li, 2024. "Numerical Simulation on Two-Phase Ejector with Non-Condensable Gas," Energies, MDPI, vol. 17(6), pages 1-19, March.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:6:p:1341-:d:1354972
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/6/1341/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/6/1341/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Carlo Cravero & Davide De Domenico & Davide Marsano, 2023. "Uncertainty Quantification Analysis of Exhaust Gas Plume in a Crosswind," Energies, MDPI, vol. 16(8), pages 1-22, April.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Michał Frant & Stanisław Kachel & Wojciech Maślanka, 2023. "Gust Modeling with State-of-the-Art Computational Fluid Dynamics (CFD) Software and Its Influence on the Aerodynamic Characteristics of an Unmanned Aerial Vehicle," Energies, MDPI, vol. 16(19), pages 1-19, September.
    2. Mingjun Liu & Zhenjiu Zhang & Zhuoming Liang & Haibing Xiao & Huanlong Chen & Xianqing Yang & Changxiao Shao, 2023. "New Insights into Flow for a Low-Bypass-Ratio Transonic Fan with Optimized Rotor," Energies, MDPI, vol. 16(21), pages 1-19, October.
    3. Maria Hurnik & Piotr Ciuman & Zbigniew Popiolek, 2024. "Eddy–Viscosity Reynolds-Averaged Navier–Stokes Modeling of Air Distribution in a Sidewall Jet Supplied into a Room," Energies, MDPI, vol. 17(5), pages 1-19, March.
    4. Alberto Savino & Andrea Ferreri & Alex Zanotti, 2024. "Validation of a Mid-Fidelity Numerical Approach for Wind Turbine Aerodynamics Characterization," Energies, MDPI, vol. 17(7), pages 1-23, March.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:6:p:1341-:d:1354972. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.