IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v11y2018i8p2168-d164537.html
   My bibliography  Save this article

Autoignition Behavior of an Ethanol-Methylcellulose Gel Droplet in a Hot Environment

Author

Listed:
  • Donggi Lee

    (Department of Aerospace Engineering, Korea Advanced Institute of Science and Technology (KAIST), 291 Daehak-ro, Yuseong-gu, Daejeon 34141, Korea)

  • Jonghan Won

    (Department of Aerospace Engineering, Korea Advanced Institute of Science and Technology (KAIST), 291 Daehak-ro, Yuseong-gu, Daejeon 34141, Korea)

  • Seung Wook Baek

    (Department of Aerospace Engineering, Korea Advanced Institute of Science and Technology (KAIST), 291 Daehak-ro, Yuseong-gu, Daejeon 34141, Korea)

  • Hyemin Kim

    (Department of Aeronautical & Mechanical Design Engineering, Korea National University of Transportation, Daehak-ro 50, Chungju City 27469, Korea)

Abstract

Autoignition of an ethanol-based gel droplet was experimentally investigated by adding 10 wt % of methylcellulose as gellant to liquid ethanol. Experimental studies of the ignition behavior of the gel droplet were found to be quite rare. The initial droplet diameter was 1.17 ± 0.23 mm. The gel droplet was suspended on a K-type thermocouple and its evaporation, ignition and combustion characteristics were evaluated and compared with pure ethanol at an ambient temperature of 600, 700, and 800 °C under atmospheric pressure conditions. The gel droplet exhibited swelling and vapor jetting phenomena. Before ignition, a linear decrease in droplet diameter followed by a sudden increase was repeatedly observed, which was caused by evaporation and swelling processes, respectively. Major droplet swelling was detected just before the onset of ignition at all temperatures. But no further swelling was detected after ignition. For the gel droplet, the ignition delay accounted for 93% of the droplet lifetime at 600 °C, and 88% at 700 °C, but only 31% at 800 °C. Its average burning rate was also evaluated for all temperatures. At 800 °C, the gellant layer no longer exerts any influence on the combustion of the gel droplet.

Suggested Citation

  • Donggi Lee & Jonghan Won & Seung Wook Baek & Hyemin Kim, 2018. "Autoignition Behavior of an Ethanol-Methylcellulose Gel Droplet in a Hot Environment," Energies, MDPI, vol. 11(8), pages 1-11, August.
    • Handle: RePEc:gam:jeners:v:11:y:2018:i:8:p:2168-:d:164537
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/11/8/2168/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/11/8/2168/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zejun Liu & Jianjun Wu & He Zhen & Xiaoping Hu, 2013. "Numerical Simulation on Head-On Binary Collision of Gel Propellant Droplets," Energies, MDPI, vol. 6(1), pages 1-16, January.
    2. Zejun Liu & Xiaoping Hu & Zhen He & Jianjun Wu, 2012. "Experimental Study on the Combustion and Microexplosion of Freely Falling Gelled Unsymmetrical Dimethylhydrazine (UDMH) Fuel Droplets," Energies, MDPI, vol. 5(8), pages 1-11, August.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Jonghan Won & Seung Wook Baek & Hyemin Kim & Hookyung Lee, 2019. "The Viscosity and Combustion Characteristics of Single-Droplet Water-Diesel Emulsion," Energies, MDPI, vol. 12(10), pages 1-12, May.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Mhadi A. Ismael & Morgan R. Heikal & A. Rashid A. Aziz & Cyril Crua, 2018. "The Effect of Fuel Injection Equipment of Water-In-Diesel Emulsions on Micro-Explosion Behaviour," Energies, MDPI, vol. 11(7), pages 1-13, June.
    2. Svetlana Kropotova & Pavel Strizhak, 2021. "Collisions of Liquid Droplets in a Gaseous Medium under Conditions of Intense Phase Transformations: Review," Energies, MDPI, vol. 14(19), pages 1-27, September.
    3. Zejun Liu & Jianjun Wu & He Zhen & Xiaoping Hu, 2013. "Numerical Simulation on Head-On Binary Collision of Gel Propellant Droplets," Energies, MDPI, vol. 6(1), pages 1-16, January.
    4. Dmitrii V. Antonov & Roman M. Fedorenko & Leonid S. Yanovskiy & Pavel A. Strizhak, 2023. "Physical and Mathematical Models of Micro-Explosions: Achievements and Directions of Improvement," Energies, MDPI, vol. 16(16), pages 1-16, August.
    5. Dmitrii V. Antonov & Roman M. Fedorenko & Pavel A. Strizhak, 2022. "Micro-Explosion Phenomenon: Conditions and Benefits," Energies, MDPI, vol. 15(20), pages 1-19, October.
    6. Jin Wu & Frederick Nii Ofei Bruce & Xin Bai & Xuan Ren & Yang Li, 2023. "Insights into the Reaction Kinetics of Hydrazine-Based Fuels: A Comprehensive Review of Theoretical and Experimental Methods," Energies, MDPI, vol. 16(16), pages 1-23, August.
    7. Olga Gaidukova & Pavel Strizhak, 2021. "Critical Conditions for the Ignition of a Gel Fuel under Different Heating Schemes," Energies, MDPI, vol. 14(21), pages 1-16, October.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:11:y:2018:i:8:p:2168-:d:164537. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.