IDEAS home Printed from https://ideas.repec.org/a/gam/jcltec/v5y2023i3p57-1158d1244945.html
   My bibliography  Save this article

Performance Analysis of Conventional IPMSM and NCPM Based IPMSM

Author

Listed:
  • Vijaya Kumar Jonnalagadda

    (Department of Electrical and Electronics Engineering, Anil Neerukonda Institute of Technology & Sciences (ANITS), Visakhapatnam 531162, Andhra Pradesh, India)

  • Narasimhulu Tammminana

    (Department of Electrical and Electronics Engineering, Anil Neerukonda Institute of Technology & Sciences (ANITS), Visakhapatnam 531162, Andhra Pradesh, India)

  • Raja Rao Guntu

    (Department of Electrical and Electronics Engineering, Anil Neerukonda Institute of Technology & Sciences (ANITS), Visakhapatnam 531162, Andhra Pradesh, India)

  • Surender Reddy Salkuti

    (Department of Railroad and Electrical Engineering, Woosong University, Daejeon 34606, Republic of Korea)

Abstract

This paper proposes a NCPM (Nano-composite coated permanent magnets)-based IPMSM (Interior Permanent Magnet Synchronous Motor) electric drive system, especially applicable for electric vehicles (EV). For an EV, an increase in the “T/A (torque per ampere)” condition is highly recommended, as it directly affects the maximum distance run by EV on a single charge. Due to NCPM, a substantial increase in magnetic flux intensity, resistance to corrosion and Curie temperature are observed. As a result, the proposed drive clearly exhibits a higher power to weight ratio. Also, it is capable of delivering higher T/A to the drive system without any considerable change in two important factors of EV: (1) mass and volume of the drive system (2) battery capacity of the drive system. Moreover, NCPM performance is less susceptible to temperature variation, which makes it an appropriate candidate for vehicular applications, where temperature inconsistency could be a common issue during working conditions. Also, NCPM-based IPMSM offers a quicker speed response than conventional IPMSM, thus providing higher acceleration, which is one of the important performance factors for vehicular applications. A vector controlled mathematical model of IPMSM and NCPM-based IPMSM is tested for various speed commands. Also, the NCPM-based IPMSM, in the proposed configuration, is fed from a three-level DCMLI (diode clamped multi-level inverter), as the drive system is considered for medium to high power applications. A comparative performance analysis is carried out between the proposed drive system and a conventional IPMSM-based drive system using MATLAB/SIMULINK to indicate the efficacy of the proposed configuration.

Suggested Citation

  • Vijaya Kumar Jonnalagadda & Narasimhulu Tammminana & Raja Rao Guntu & Surender Reddy Salkuti, 2023. "Performance Analysis of Conventional IPMSM and NCPM Based IPMSM," Clean Technol., MDPI, vol. 5(3), pages 1-19, September.
  • Handle: RePEc:gam:jcltec:v:5:y:2023:i:3:p:57-1158:d:1244945
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2571-8797/5/3/57/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/2571-8797/5/3/57/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Wang Yin & Maria V. Alekseeva (Bykova) & Robertus Hendrikus Venderbosch & Vadim A. Yakovlev & Hero Jan Heeres, 2020. "Catalytic Hydrotreatment of the Pyrolytic Sugar and Pyrolytic Lignin Fractions of Fast Pyrolysis Liquids Using Nickel Based Catalysts," Energies, MDPI, vol. 13(1), pages 1-25, January.
    2. Bo He & Brahmanandam Javvaji & Xiaoying Zhuang, 2019. "Characterizing Flexoelectricity in Composite Material Using the Element-Free Galerkin Method," Energies, MDPI, vol. 12(2), pages 1-18, January.
    3. Nuofan Zou & Yan Yan & Tingna Shi & Peng Song, 2021. "Wide Speed Range Operation Strategy of Indirect Matrix Converter–Surface Mounted Permanent Magnet Synchronous Motor Drive," Energies, MDPI, vol. 14(8), pages 1-24, April.
    4. Xue Xue & Menghan Cheng & Tianyu Hou & Guanhua Wang & Nan Peng & Rui Liang, 2020. "Accurate Location of Faults in Transmission Lines by Compensating for the Electrical Distance," Energies, MDPI, vol. 13(3), pages 1-11, February.
    5. Keun-Young Yoon & Soo-Whang Baek, 2019. "Robust Design Optimization with Penalty Function for Electric Oil Pumps with BLDC Motors," Energies, MDPI, vol. 12(1), pages 1-14, January.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Łukasz Knypiński & Karol Pawełoszek & Yvonnick Le Menach, 2020. "Optimization of Low-Power Line-Start PM Motor Using Gray Wolf Metaheuristic Algorithm," Energies, MDPI, vol. 13(5), pages 1-11, March.
    2. Xinmin Li & Guokai Jiang & Wei Chen & Tingna Shi & Guozheng Zhang & Qiang Geng, 2019. "Commutation Torque Ripple Suppression Strategy of Brushless DC Motor Considering Back Electromotive Force Variation," Energies, MDPI, vol. 12(10), pages 1-14, May.
    3. Marek Pawel Ciurys & Wieslaw Fiebig, 2021. "Experimental Investigation of a Double-Acting Vane Pump with Integrated Electric Drive," Energies, MDPI, vol. 14(18), pages 1-15, September.
    4. Roland Kasper & Dmytro Golovakha, 2020. "Combined Optimal Torque Feedforward and Modal Current Feedback Control for Low Inductance PM Motors," Energies, MDPI, vol. 13(23), pages 1-16, November.
    5. Mari Rowena C. Tanquilut & Homer C. Genuino & Erwin Wilbers & Rossana Marie C. Amongo & Delfin C. Suministrado & Kevin F. Yaptenco & Marilyn M. Elauria & Jessie C. Elauria & Hero J. Heeres, 2020. "Biorefining of Pigeon Pea: Residue Conversion by Pyrolysis," Energies, MDPI, vol. 13(11), pages 1-19, June.
    6. Jin Zhou & Shanhu Li & Jianning Zhang & Tianrui Fang & Xiuyun Zhang, 2022. "Research on Space Vector Overmodulation Technology of Two-Level PWM Converters," Energies, MDPI, vol. 15(19), pages 1-17, September.
    7. Fugang Zhai & Liu Yang & Wenqi Fu & Haisheng Tong & Tianyu Zhao, 2022. "The Effects of Permanent Magnet Segmentations on Electromagnetic Performance in Ironless Brushless DC Motors," Energies, MDPI, vol. 15(2), pages 1-18, January.
    8. Mohsin Raza & Abrar Inayat & Ashfaq Ahmed & Farrukh Jamil & Chaouki Ghenai & Salman R. Naqvi & Abdallah Shanableh & Muhammad Ayoub & Ammara Waris & Young-Kwon Park, 2021. "Progress of the Pyrolyzer Reactors and Advanced Technologies for Biomass Pyrolysis Processing," Sustainability, MDPI, vol. 13(19), pages 1-42, October.
    9. Huaibao Wang & Sheng Wang & Hao Ding & Changli Shi & Dongqiang Jia & Chao Chen & Josep M. Guerrero, 2022. "An Novel Six-Segment Modulation Strategy for Three-Phase Isolated PFC Converter," Energies, MDPI, vol. 15(7), pages 1-14, April.
    10. Xiaoying Zhuang & Binh Huy Nguyen & Subbiah Srivilliputtur Nanthakumar & Thai Quoc Tran & Naif Alajlan & Timon Rabczuk, 2020. "Computational Modeling of Flexoelectricity—A Review," Energies, MDPI, vol. 13(6), pages 1-29, March.
    11. Jean-Michel Grenier & Ramón Pérez & Mathieu Picard & Jérôme Cros, 2021. "Magnetic FEA Direct Optimization of High-Power Density, Halbach Array Permanent Magnet Electric Motors," Energies, MDPI, vol. 14(18), pages 1-19, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jcltec:v:5:y:2023:i:3:p:57-1158:d:1244945. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.