IDEAS home Printed from https://ideas.repec.org/a/zib/zbngwk/v5y2021i2p53-57.html
   My bibliography  Save this article

Designing, Fabrication And Performance Evaluation Of Agricultural Composter For Economical Biowaste Management

Author

Listed:
  • Saira Shehzadi

    (Department of Structures & Environmental Engineering Faisalabad Pakistan)

  • M. Azhar Ali

    (Department of Food Engineering, University of Agriculture Faisalabad Pakistan)

  • M. Usman Farid

    (Department of Structures & Environmental Engineering Faisalabad Pakistan)

  • M. Kashif

    (Department of Food Engineering, University of Agriculture Faisalabad Pakistan)

Abstract

In the last few years, the rapid increase of human population are creating many environmental problems because of intensification of human activities. A huge amount of wastes are generated from industries including food and agriculture industries. It is essential to protect the natural resources. It can be done with best management practices of agriculture waste in future Composting is the best method to handle the food, agricultural and industrial waste. The main objective of this research is the design and fabrication of an indigenous composter to conserve the agriculture waste. Composter structure is based on two shells. One is inner shells which is having diameter of 48 inches and outer shell having diameter of 52 inches. Between these two shells heat in the form of steam is circulated to give high temperature for pasteurization of compost. Raw material is added in the inner shell. Two gears are attached with this composter structure. One is driving gear which is also small gear attached with motor. Other one is larger gear which is adjusted according to our desire RPM requirement. Larger gear further rotates the shaft present in the inner shell of composter. Gear motor is used having the power of 3355 Watt Watt. Material used for this composter was mild steel. A boiler was attached to this composter to flow the steam in outer shell of composter. Agriculture waste considered for this research corn straw waste. The analysis have been done in a composter for compost effecting parameters. The effect of three independent parameters pressure, RPM and feeding rate was analyzed on the composting time of waste. Results indicated that increase in the RPM the time of composting also increase because of oxygen cannot consumed fully at higher RPM. Whereas the increase in feeding rate decrease the time of composting because the greater number of microbial activities generated in the composting process and compost prepared in less time. In case of pressure, higher the pressure the time of composting decreases because at higher pressure the time rise quickly and thermophilic conditions occurs quickly. At RPM 12 and feeding rate 15kg in 62.89± 2.26 time compost was prepared it was the least time as compare to others. At 10 RPM and 1 bar pressure composting time notice was 65.33±2.60. In combination of feeding rate and pressure, at feeding rate 15kg and pressure 0.5 bar least time noticed 63.00± 2.35.

Suggested Citation

  • Saira Shehzadi & M. Azhar Ali & M. Usman Farid & M. Kashif, 2021. "Designing, Fabrication And Performance Evaluation Of Agricultural Composter For Economical Biowaste Management," Engineering Heritage Journal (GWK), Zibeline International Publishing, vol. 5(2), pages 53-57, November.
    • Handle: RePEc:zib:zbngwk:v:5:y:2021:i:2:p:53-57
    DOI: 10.26480/gwk.02.2021.53.57
    as

    Download full text from publisher

    File URL: https://enggheritage.com/download/14290/
    Download Restriction: no
    File URL: https://libkey.io/10.26480/gwk.02.2021.53.57?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    References listed on IDEAS

    as
    1. Ghaffar, Mohammed A., 1995. "The energy supply situation in the rural sector of Pakistan and the potential of renewable energy technologies," Renewable Energy, Elsevier, vol. 6(8), pages 941-976.
    2. Ashraf Chaudhry, M. & Raza, R. & Hayat, S.A., 2009. "Renewable energy technologies in Pakistan: Prospects and challenges," Renewable and Sustainable Energy Reviews, Elsevier, vol. 13(6-7), pages 1657-1662, August.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ahmed, Saeed & Mahmood, Anzar & Hasan, Ahmad & Sidhu, Guftaar Ahmad Sardar & Butt, Muhammad Fasih Uddin, 2016. "A comparative review of China, India and Pakistan renewable energy sectors and sharing opportunities," Renewable and Sustainable Energy Reviews, Elsevier, vol. 57(C), pages 216-225.
    2. Bhutto, Abdul Waheed & Bazmi, Aqeel Ahmed & Zahedi, Gholamreza, 2011. "Greener energy: Issues and challenges for Pakistan--Biomass energy prospective," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(6), pages 3207-3219, August.
    3. Tahir, Z.R. & Asim, Muhammad, 2018. "Surface measured solar radiation data and solar energy resource assessment of Pakistan: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 81(P2), pages 2839-2861.
    4. Riaz Uddin & Abdurrahman Javid Shaikh & Hashim Raza Khan & Muhammad Ayaz Shirazi & Athar Rashid & Saad Ahmed Qazi, 2021. "Renewable Energy Perspectives of Pakistan and Turkey: Current Analysis and Policy Recommendations," Sustainability, MDPI, vol. 13(6), pages 1-28, March.
    5. Mahmood, Anzar & Javaid, Nadeem & Zafar, Adnan & Ali Riaz, Raja & Ahmed, Saeed & Razzaq, Sohail, 2014. "Pakistan's overall energy potential assessment, comparison of LNG, TAPI and IPI gas projects," Renewable and Sustainable Energy Reviews, Elsevier, vol. 31(C), pages 182-193.
    6. Ullah, Irfan & Chaudhry, Qamar-uz-Zaman & Chipperfield, Andrew J., 2010. "An evaluation of wind energy potential at Kati Bandar, Pakistan," Renewable and Sustainable Energy Reviews, Elsevier, vol. 14(2), pages 856-861, February.
    7. Arshad, Muhammad & Bano, Ijaz & Khan, Nasrullah & Shahzad, Mirza Imran & Younus, Muhammad & Abbas, Mazhar & Iqbal, Munawar, 2018. "Electricity generation from biogas of poultry waste: An assessment of potential and feasibility in Pakistan," Renewable and Sustainable Energy Reviews, Elsevier, vol. 81(P1), pages 1241-1246.
    8. Khan, Mohammad Azam & Latif, Noman, 2010. "Environmental friendly solar energy in Pakistan's scenario," Renewable and Sustainable Energy Reviews, Elsevier, vol. 14(8), pages 2179-2181, October.
    9. Tükenmez, Mine & Demireli, Erhan, 2012. "Renewable energy policy in Turkey with the new legal regulations," Renewable Energy, Elsevier, vol. 39(1), pages 1-9.
    10. Maqbool, Rashid, 2018. "Efficiency and effectiveness of factors affecting renewable energy projects; an empirical perspective," Energy, Elsevier, vol. 158(C), pages 944-956.
    11. Leezna Saleem & Imran Ahmad Siddiqui & Intikhab Ulfat, 2021. "The prioritization of renewable energy technologies in Pakistan: An urgent need," ECONOMICS AND POLICY OF ENERGY AND THE ENVIRONMENT, FrancoAngeli Editore, vol. 2021(1), pages 81-103.
    12. Yasir Ahmed Solangi & Qingmei Tan & Muhammad Waris Ali Khan & Nayyar Hussain Mirjat & Ifzal Ahmed, 2018. "The Selection of Wind Power Project Location in the Southeastern Corridor of Pakistan: A Factor Analysis, AHP, and Fuzzy-TOPSIS Application," Energies, MDPI, vol. 11(8), pages 1-26, July.
    13. Sheikh, Munawar A., 2010. "Energy and renewable energy scenario of Pakistan," Renewable and Sustainable Energy Reviews, Elsevier, vol. 14(1), pages 354-363, January.
    14. Rauf, Omer & Wang, Shujie & Yuan, Peng & Tan, Junzhe, 2015. "An overview of energy status and development in Pakistan," Renewable and Sustainable Energy Reviews, Elsevier, vol. 48(C), pages 892-931.
    15. Wajahat Ullah Khan Tareen & Zuha Anjum & Nabila Yasin & Leenah Siddiqui & Ifzana Farhat & Suheel Abdullah Malik & Saad Mekhilef & Mehdi Seyedmahmoudian & Ben Horan & Mohamed Darwish & Muhammad Aamir &, 2018. "The Prospective Non-Conventional Alternate and Renewable Energy Sources in Pakistan—A Focus on Biomass Energy for Power Generation, Transportation, and Industrial Fuel," Energies, MDPI, vol. 11(9), pages 1-49, September.
    16. Hira Soomro & Syed Feroz Shah & Wasayo Sanam Sahito & Mohammad Aslam Uqaili & Laveet Kumar & Jonathan Daniel Nixon & Khanji Harijan, 2022. "Assessment of Sustainable Biomass Energy Technologies in Pakistan Using the Analytical Hierarchy Process," Sustainability, MDPI, vol. 14(18), pages 1-19, September.
    17. Nandal, Vinod & Kumar, Raj & Singh, S.K., 2019. "Barriers identification and analysis of solar power implementation in Indian thermal power plants: An Interpretative Structural Modeling approach," Renewable and Sustainable Energy Reviews, Elsevier, vol. 114(C), pages 1-1.
    18. Uddin, Waqar & Khan, B. & Shaukat, Neelofar & Majid, Muhammad & Mujtaba, G. & Mehmood, Arshad & Ali, S.M. & Younas, U. & Anwar, Muhammad & Almeshal, Abdullah M., 2016. "Biogas potential for electric power generation in Pakistan: A survey," Renewable and Sustainable Energy Reviews, Elsevier, vol. 54(C), pages 25-33.
    19. Rehman, Muhammad Saif Ur & Rashid, Naim & Saif, Ameena & Mahmood, Tariq & Han, Jong-In, 2013. "Potential of bioenergy production from industrial hemp (Cannabis sativa): Pakistan perspective," Renewable and Sustainable Energy Reviews, Elsevier, vol. 18(C), pages 154-164.
    20. Zeb, K. & Ali, S.M. & Khan, B. & Mehmood, C.A. & Tareen, N. & Din, W. & Farid, U. & Haider, A., 2017. "A survey on waste heat recovery: Electric power generation and potential prospects within Pakistan," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 1142-1155.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:zib:zbngwk:v:5:y:2021:i:2:p:53-57. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Zibeline International Publishing (email available below). General contact details of provider: https://enggheritage.com/ .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.