IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v86y2009i10p2141-2151.html
   My bibliography  Save this article

Modeling HCCI combustion: Modification of a multi-zone model and comparison to experimental results at varying boost pressure

Author

Listed:
  • Komninos, N.P.

Abstract

The present study presents a comparison of the results obtained from a modified HCCI multi-zone model to experimental measurements, at different load and boost pressure conditions. The multi-zone model includes a modified sub-model for the wall heat transfer and accounts for the heat transfer between zones. Gas mixing between cold and hot regions of the combustion chamber, which is of major importance for the emissions formation, is also accounted for throughout compression, combustion and expansion. Combustion is modeled using a reduced set of chemical reactions coupled with a chemical kinetics solver. A refined zone configuration near the combustion chamber wall was used, in order to obtain a high resolution at the emissions formation regions. The pressure traces and emissions of nine experimental cases were compared to the multi-zone model results. In these cases the equivalence ratio and the boost pressure were varied, while maintaining constant engine speed. The results show adequate agreement with the pressure traces. The emissions trends are also adequately captured, with the absolute values presenting some deviation from the experimental cases especially for the HC and CO emissions at the relatively low air-fuel equivalence ratios.

Suggested Citation

  • Komninos, N.P., 2009. "Modeling HCCI combustion: Modification of a multi-zone model and comparison to experimental results at varying boost pressure," Applied Energy, Elsevier, vol. 86(10), pages 2141-2151, October.
    • Handle: RePEc:eee:appene:v:86:y:2009:i:10:p:2141-2151
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306-2619(09)00036-1
    Download Restriction: Full text for ScienceDirect subscribers only
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Wu, Horng-Wen & Wang, Ren-Hung & Ou, Dung-Je & Chen, Ying-Chuan & Chen, Teng-yu, 2011. "Reduction of smoke and nitrogen oxides of a partial HCCI engine using premixed gasoline and ethanol with air," Applied Energy, Elsevier, vol. 88(11), pages 3882-3890.
    2. Maurya, Rakesh Kumar & Agarwal, Avinash Kumar, 2011. "Experimental investigation on the effect of intake air temperature and air-fuel ratio on cycle-to-cycle variations of HCCI combustion and performance parameters," Applied Energy, Elsevier, vol. 88(4), pages 1153-1163, April.
    3. Hou, Junxing & Qiao, Xinqi & Wang, Zhen & Liu, Wei & Huang, Zhen, 2010. "Characterization of knocking combustion in HCCI DME engine using wavelet packet transform," Applied Energy, Elsevier, vol. 87(4), pages 1239-1246, April.
    4. Komninos, N.P. & Rakopoulos, C.D., 2012. "Modeling HCCI combustion of biofuels: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(3), pages 1588-1610.
    5. Saravanan, N. & Nagarajan, G., 2010. "Performance and emission studies on port injection of hydrogen with varied flow rates with Diesel as an ignition source," Applied Energy, Elsevier, vol. 87(7), pages 2218-2229, July.
    6. Ghazimirsaied, Ahmad & Koch, Charles Robert, 2012. "Controlling cyclic combustion timing variations using a symbol-statistics predictive approach in an HCCI engine," Applied Energy, Elsevier, vol. 92(C), pages 133-146.
    7. Rakopoulos, C.D. & Kosmadakis, G.M. & Dimaratos, A.M. & Pariotis, E.G., 2011. "Investigating the effect of crevice flow on internal combustion engines using a new simple crevice model implemented in a CFD code," Applied Energy, Elsevier, vol. 88(1), pages 111-126, January.
    8. Lu, Xingcai & Zhou, Xiaoxin & Ji, Libin & Yang, Zheng & Han, Dong & Huang, Chen & Huang, Zhen, 2013. "Experimental studies on the dual-fuel sequential combustion and emission simulation," Energy, Elsevier, vol. 51(C), pages 358-373.
    9. Gan, Suyin & Ng, Hoon Kiat & Pang, Kar Mun, 2011. "Homogeneous Charge Compression Ignition (HCCI) combustion: Implementation and effects on pollutants in direct injection diesel engines," Applied Energy, Elsevier, vol. 88(3), pages 559-567, March.
    10. Krishna, Addepalli S. & Mallikarjuna, J.M. & Kumar, Davinder, 2016. "Effect of engine parameters on in-cylinder flows in a two-stroke gasoline direct injection engine," Applied Energy, Elsevier, vol. 176(C), pages 282-294.
    11. Komninos, N.P., 2015. "The effect of thermal stratification on HCCI combustion: A numerical investigation," Applied Energy, Elsevier, vol. 139(C), pages 291-302.
    12. Komninos, N.P. & Rakopoulos, C.D., 2016. "Heat transfer in hcci phenomenological simulation models: A review," Applied Energy, Elsevier, vol. 181(C), pages 179-209.
    13. Broekaert, Stijn & De Cuyper, Thomas & De Paepe, Michel & Verhelst, Sebastian, 2017. "Evaluation of empirical heat transfer models for HCCI combustion in a CFR engine," Applied Energy, Elsevier, vol. 205(C), pages 1141-1150.
    14. Visakhamoorthy, Sona & Tzanetakis, Tommy & Haggith, Dale & Sobiesiak, Andrzej & Wen, John Z., 2012. "Numerical study of a homogeneous charge compression ignition (HCCI) engine fueled with biogas," Applied Energy, Elsevier, vol. 92(C), pages 437-446.
    15. Mohamed Ismail, Harun & Ng, Hoon Kiat & Gan, Suyin, 2012. "Evaluation of non-premixed combustion and fuel spray models for in-cylinder diesel engine simulation," Applied Energy, Elsevier, vol. 90(1), pages 271-279.
    16. Komninos, N.P. & Kosmadakis, G.M., 2011. "Heat transfer in HCCI multi-zone modeling: Validation of a new wall heat flux correlation under motoring conditions," Applied Energy, Elsevier, vol. 88(5), pages 1635-1648, May.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:86:y:2009:i:10:p:2141-2151. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.